CFD Modeling of Flow, Combustion and NOx Emission in a Wall-Fired Boiler at Different Low-Load Operating Conditions
Haopeng Wang,Haoze Jin,Zhi Yang,Shanshan Deng,Xuehong Wu,Jingxue An,Ranran Sheng,Shuguang Ti
DOI: https://doi.org/10.1016/j.applthermaleng.2023.121824
IF: 6.4
2024-01-01
Applied Thermal Engineering
Abstract:In the context of achieving carbon peaking and carbon neutrality, the implementation of flexible peak shaving techniques is of significant importance to coal-fired units. Operating coal-fired units under different low loads can result in decreased combustion efficiency, unstable combustion, and increased emissions of nitrogen oxides (NOx) during the combustion of pulverized coal. However, few studies have been carried out wall-fired boiler under low-load operation in most papers. This paper employs numerical simulation to investigate the flow, temperature, composition concentration fields, as well as combustion stability and NOx emission characteristics of a 600 MWe wall-fired under various low-load (specifically, 400, 300, 240 and 200 MWe) conditions. The simulations demonstrate that reducing the boiler load leads to decreases in the amount of filling gas and the average temperature of the furnace. Despite the overall decrease in average furnace temperature with load reduction, the central part of the furnace can reach 1400 K at low load (200 MWe), due to the strong flame stability of centrally fuel-rich burner. The NOx concentrations for 400, 300, 240, and 200 MWe were 475.9, 498.4, 361.9 and 259.7 mg/Nm3, respectively. The NOx concentration initially increases with the load reduction, and decreases as the load is further reduced. Considering the broad industrial application prospect of flexible peak shaving of coal-fired boilers, these research results provide guidance and suggestions for different load operation of wall-fired boilers, and provide theoretical support for low load stable combustion operation of wall-fired boilers.