Abstract:Abstract Heat transfer within the rotating compressor cavity of an aero-engine is predominantly governed by buoyancy, which can be characterized by the Grashof number. Unsteady and unstable buoyancy-induced flow structures influence the temperatures and stresses in the compressor rotors, and these affect the radial growth of the disks. In addition, the heat transfer from the disks and shroud increases the temperature of the throughflow of cooling air. This paper contains two connected parts. First, a heat transfer correlation for the shroud of a rotating cavity was determined from steady-state heat flux measurements collected in the bath compressor-cavity rig at engine-simulated conditions. The Nusselt numbers were based on the cavity air temperature adjacent to the shroud, which was predicted using the Owen–Tang buoyancy model. Heat transfer from the shroud was consistent with free convection from a horizontal plate in a gravitational field. Maximum likelihood estimation was used with a Rayleigh–Bénard equation to correlate the shroud Nusselt number with the local Grashof number. Second, an energy balance was used to calculate the enthalpy rise of the axial throughflow from the measured disk and shroud heat fluxes. Disk fluxes were derived from radial distributions of measured steady-state disk temperatures using a Bayesian model and the equations for a circular fin. The calculated throughflow temperature rise was consistent with direct thermocouple measurements. The complex, three-dimensional flow near the cavity entrance can result in enthalpy exchange penetrating upstream in the throughflow, and rotationally induced flow can create upstream axial flow in the outer part of the annulus.

Experimental Investigation on Heat Transfer in Shrouded Rotating Disk with High-Positioned Air Inflow

Experiment investigation on transient heat transfer in rotor-stator system with high-positioned air inflow

Numerical calculation for flow and heat transfer of a shrouded rotating disk with high-positioned air-inlet

Experimental Investigation of Unsteady Heat Transfer Between Counter-Rotating Disks

Numerical Simulation of Fluid Flow and Heat Transfer in Shrouded Rotating Disk with High Positioned Axial Inlet

Experimental Investigation of Heat Transfer in a Rotor–stator Cavity with Cooling Air Inlet at Low Radius

Experimental investigation on frictional loss in shrouded rotating disk with high-positioned air inflow

Experiment Investigation of Unsteady Heat Transfer Between Co-Rotating Disks

Heat transfer measurements on a rotating disk with discrete receiver holes

Windage Heating in a Shrouded Rotor-Stator System.

Numerical Investigation of Windage Heating Within Shrouded Rotor-Stator Cavity System with Central Inflow

Numerical investigation on the flow and heat transfer in a rotor-stator disc cavity

Computational Investigation of Heat Transfer Characteristics of Counter-Rotating Turbine Disks with Annulus

Investigation on Heat Transfer Characteristic and Optimization of the Cooling Air Inlet for the Twin-Web Turbine Disk

Heat Transfer Characteristics Of A Rotor-Stator System With Small Radial Outflow

Transient measurement for measuring the heat transfer in a rotating cavity with a high rotational speed

Heat transfer in direct transfer pre-swirl rotor-stator system

Experimental Study of Flow Distribution Characteristics for a Rotor-Stator System

Analysis of Air–Oil Flow and Heat Transfer inside a Grooved Rotating-Disk System

Analysis of Shroud and Disk Heat Transfer in Aero-Engine Compressor Rotors

Experimental Investigation on the Flow and Flow-Rotor Heat Transfer in a Rotor-Stator Spinning Disk Reactor