Abstract:Abstract Heat transfer within the rotating compressor cavity of an aero-engine is predominantly governed by buoyancy, which can be characterized by the Grashof number. Unsteady and unstable buoyancy-induced flow structures influence the temperatures and stresses in the compressor rotors, and these affect the radial growth of the disks. In addition, the heat transfer from the disks and shroud increases the temperature of the throughflow of cooling air. This paper contains two connected parts. First, a heat transfer correlation for the shroud of a rotating cavity was determined from steady-state heat flux measurements collected in the bath compressor-cavity rig at engine-simulated conditions. The Nusselt numbers were based on the cavity air temperature adjacent to the shroud, which was predicted using the Owen–Tang buoyancy model. Heat transfer from the shroud was consistent with free convection from a horizontal plate in a gravitational field. Maximum likelihood estimation was used with a Rayleigh–Bénard equation to correlate the shroud Nusselt number with the local Grashof number. Second, an energy balance was used to calculate the enthalpy rise of the axial throughflow from the measured disk and shroud heat fluxes. Disk fluxes were derived from radial distributions of measured steady-state disk temperatures using a Bayesian model and the equations for a circular fin. The calculated throughflow temperature rise was consistent with direct thermocouple measurements. The complex, three-dimensional flow near the cavity entrance can result in enthalpy exchange penetrating upstream in the throughflow, and rotationally induced flow can create upstream axial flow in the outer part of the annulus.

Numerical calculation for flow and heat transfer of a shrouded rotating disk with high-positioned air-inlet

Numerical simulation of internal flow in forward-curved centrifugal fan

Three-dimensional Numerical Simulation of the Internal Flow in the Centrifugal Fan

Numerical Study of Heat Flux Reduction Mechanism of the Counterflowing Jet in Rarefied Flows

LAMINAR FLOW AND HEAT TRANSFER IN THE DEVELOPING REGION OF HELICAL SQUARE DUCTS

Summary of Numerical Simulation of the Internal Flow in the Turbomachinery

Numerical investigation on the flow and heat transfer in a rotor-stator disc cavity

Analysis of Air–Oil Flow and Heat Transfer inside a Grooved Rotating-Disk System

Analysis of Shroud and Disk Heat Transfer in Aero-Engine Compressor Rotors

Numerial Simulation of Flow Field in the Multi-Blade Centrifugal Fan of Range Hoods

The Highly Turbulent Flow and Heat Transfer in Semi-Closed Rotating Disc Cavity

Numerical Study of Unsteady Flow and Heat Transfer of Circular Tangential Direction Jets Flowing over the Inner Cylinder Surface in the Annular Chamber

Analysis of cavity disk heat transfer by solving inverse heat transfer problem

Numerical Investigation of Flows Between Rotating Disks

Numerical investigation of flow and heat transfer between concentric cylinders with slit wall

Experimental Investigation of Heat Transfer in a Rotor–stator Cavity with Cooling Air Inlet at Low Radius

Numerical Research of the Inner Flow Field of an Intermediate Pressure Steam Turbine's Inlet Chamber

Theoretical Calculation Of The Critical Heat Flux In Annular Upward Flow In Vertical Narrow Rectangular Channels

Numerical investigation of laminar natural convective heat transfer from a horizontal triangular cylinder to its concentric cylindrical enclosure

Numerical Simulations of Three Dimensional Turbulent Flows in a Shrouded Backswept Impeller at Design and Off-Design Flow Rates Using Unstructured Grid Method

Flow Structures and Heat Transfer Characteristics in a Vaneless Counter-Rotating Turbine Cavity with Different Cooling Inflows