Abstract:This paper has experimentally studied the windage torque in a rotor-stator system with superimposed central inflow and rotor-mounted protrusions. A novel measurement method has been proposed, and the basic principle is to transform the torque of rotating components into static torque measured by using a static torquemeter. Compared with the previous research, the difference of the moment coefficient for the free plain disk in this paper is within 10%. The disk models used in the experiments included a plain disk and a rotor with 18 protrusions. Plain-disk results were obtained with axial clearances varying from 4.5 mm to 40.5 mm and a stator of the same diameter. Two test cases were performed: one was the case where the flow structure was dominated by the superimposed flow and the other was where rotation dominated the flow structure. For the plain-disk case, as turbulence parameter increases, the sensitivity of the torque to variations of G value also increases, leaving the moment coefficient as a function of the rotational and throughflow Reynolds number only. Comparing to the flow parameter, gap ratio and shroud-clearance ratio have weaker influence on frictional moment coefficient. The rotor with protrusions results showed that the gap ratio had negligible effect on the moment coefficient for the former case; however, the torque decreased by approximately 20% with the decrease of the gap ratio for the latter case. It was also found that, for different configurations, the deviation in the moment coefficient was attributed to variations in form drag. In addition, the moment coefficient was affected by the orientation of bolts with respect to the direction of rotation. The empirical correlations have been proposed for the windage losses of various bolt configurations, and a further discussion about minimizing the windage losses was conducted.

Windage Heating in a Shrouded Rotor-Stator System.

Numerical Investigation of Windage Heating Within Shrouded Rotor-Stator Cavity System with Central Inflow

Effect of Windage Heating on a Micro High-Speed Rotor-Stator Cavity

Experimental Investigation on Heat Transfer in Shrouded Rotating Disk with High-Positioned Air Inflow

Experimental Investigation on the Flow and Flow-Rotor Heat Transfer in a Rotor-Stator Spinning Disk Reactor

Windage Measurements in a Rotor-Stator System with Superimposed Cooling and Rotor-Mounted Protrusions

Experimental Investigation of Heat Transfer in a Rotor–stator Cavity with Cooling Air Inlet at Low Radius

Heat transfer measurements on a rotating disk with discrete receiver holes

Heat Transfer Characteristics Of A Rotor-Stator System With Small Radial Outflow

Experiment investigation on transient heat transfer in rotor-stator system with high-positioned air inflow

Numerical investigation on the flow and heat transfer in a rotor-stator disc cavity

Investigation on Heat Transfer Characteristic and Optimization of the Cooling Air Inlet for the Twin-Web Turbine Disk

Numerical Investigation on the Unsteady Flowfield of the Turbine Stage under Different Axial Gaps

Experimental Study of Flow Resistance and Heat Transfer in Rotor-Stator Cavity for High Pressure Turbine

Computational Investigation of Heat Transfer Characteristics of Counter-Rotating Turbine Disks with Annulus

Effects of Axial and Radial-Gap Spacing on the Local Heat-Transfer of A Shrouded Rotor-Stator System

Cooling Effectiveness of a Rotating Disk with Discrete Receiver Holes

Experimental Study of Flow Distribution Characteristics for a Rotor-Stator System

Experimental Investigation of the Flow Field Between a Rotating and a Stationary Disk at High-Positioned Air Inflow

Numerical Investigation of Turbulent Flow in an Open Rotor-Stator System

Numerical and Experimental Investigations on Windage Heating Effect of Labyrinth Seals