Abstract:Turbine blade cooling air is facilitated in part by the pre-swirl system, a crucial part of the aero-engine secondary air system. This article primarily focuses on the pre-swirl angle and the turbine co-rotating cavity in order to improve the pre-swirl system's temperature drop. It also employs the thermochromic liquid crystal test method to investigate the pre-swirl system's temperature drop characteristics and the cavity's cooling effect. The experimental parameters are measured at different flow rates when the rotational Reynolds number is between 2.97 x 106 and 4.23 x 106. The results indicate that within the experimental operating range, for the axial preswirl structure, the fluid velocity is fast and the static temperature is significantly reduced after pre-rotation. The higher the rotational Reynolds number, the lower the static temperature of the fluid passing through the receiving hole, and the higher the outlet temperature rise. The tangential velocity of the 15-degree preswirl structure is low, the static temperature of the receiving hole is high, and the average outlet temperature increases. In terms of pressure loss, the higher the rotational Reynolds number, the lower the fluid static pressure. The larger the pre-swirl flow rate, the higher the static pressure inside the cavity. The outlet static pressure of the 15-degree structure is higher than that of the 10-degree structure. The swirl ratio increases with an increasing flow rate. The swirl ratio decreases as the rotational Reynolds number increases. The 15-degree structure's swirl ratio is significantly lower than that of the 10-degree structure. Entropy generation is mostly produced along the trailing edge of the blade and in the vicinity of the wall, and the entropy generation of the 15-degree preswirl structure is higher than that of the 10-degree structure. On the disc's surface, the convective heat transfer coefficient rises with a rising dimensionless flow rate and falls with an increasing rotational Reynolds number.

Heat transfer in direct transfer pre-swirl rotor-stator system

Experiment of Flow Characteristics of Direct Transfer Pre-Swirl System

Experiment investigation on transient heat transfer in rotor-stator system with high-positioned air inflow

Numerical Investigation of the Flow and Heat Transfer Characteristics for a Pre-Swirl Rotor–stator System with Center Inflow

Cooling Effectiveness in a Rotor-Stator System with Different Pre-Swirl Angles

Experimental Investigation on Heat Transfer in Shrouded Rotating Disk with High-Positioned Air Inflow

Influence of Central Outflow on Flow and Heat Transfer in a Pre-Swirl Rotor-Stator System

Numerical investigation on the flow and heat transfer in a rotor-stator disc cavity

Numerical Investigations of the Flow and Heat Transfer in a Pre-swirl Rotor-Stator Cavity With Rim Radial Seal

Flow and heat transfer characteristics in a pre-swirl rotor-stator cavity

Numerical Simulation of Flow and Heat Transfer Performances in a Direct Transfer Pre-Swirl System

Experimental Investigation of Heat Transfer in a Rotor–stator Cavity with Cooling Air Inlet at Low Radius

Experimental Investigation of Unsteady Heat Transfer Between Counter-Rotating Disks

Experimental Investigation on the Flow and Flow-Rotor Heat Transfer in a Rotor-Stator Spinning Disk Reactor

Direct numerical simulation of turbulent heat transfer in an axially rotating pipe flow

Heat Transfer Characteristics Of A Rotor-Stator System With Small Radial Outflow

Numerical Investigation of the Pre-Swirl Rotor–stator System of the First Stage in Gas Turbine

Heat transfer measurements on a rotating disk with discrete receiver holes

Computational Investigation of Heat Transfer Characteristics of Counter-Rotating Turbine Disks with Annulus

Study on Flow and Heat Transfer Characteristics of Two Axial Preswirl Structures

Direct Numerical Simulation of Vertical Rotating Turbulent Open-Channel Flow with Heat Transfer