Abstract:The internal flow evolution of the pump was induced with impeller movement. In various conditions, the peak load on centrifugal blade under the change of rotational speed or flow rate was also changed. It would cause an error when inertia load with a safety coefficient (that was difficult to ascertain) was applied in structure design. In order to accurately analyze the impeller stress under various conditions and improve the reliability of pump, based on a mixed flow pump model, the stress distribution characteristic was analyzed under different flow rates and rotational speeds. Based on a three-dimensional calculation model including impeller, guide blade, inlet and outlet, the three-dimension incompressible turbulence flow in the centrifugal pump was simulated by using the standard k-epsilon turbulence model. Based on the sequentially coupled simulation approach, a three-dimensional finite element model of impeller was established, and the fluid-structure interaction method of the blade load transfer was discussed. The blades pressure from flow simulation, together with inertia force acting on the blade, was used as the blade loading on solid surface. The Finite Element Method (FEM) was used to calculate the stress distribution of the blade respectively under inertia load, or fluid load, or combined load. The results showed that the blade stress changed with flow rate and rotational speed. In all cases, the maximum stress on the blade appeared on the pressure side near the hub, and the maximum static stress increased with the decreasing of the flow rate and the increasing of rotational speed. There was a big difference on the static stress when inertia load, fluid load and combined loads was applied respectively. In order to more accurately calculate the stress distribution, the structure analysis should be conducted due to combined loads. The results could provide basis for the stress analysis and structure optimization of pump.

Stress Calculation and Analysis of the Integral Structure of a Swirl-Jet Absorption Tower

TO CALCULATE THE STRENGTH OF TURBINE＇S DIAPHRAGM BY USING FINITE ELEMENT METHOD

Numerical Simulation and Structure Optimization of Compressor Muffler

SOME PROBLEMS ON STRUCTURAL ANALYSIS OF COOLING TOWERS

CFD Simulation of Flow Field,temperature Field and SO2 Absorption in Flue Gas Quench Tower

Computation of Stress Distribution in a Mixed Flow Pump Based on Fluid-Structure Interaction Analysis

Finite Element Analysis of Tangential Rectangle Joint Pipe on the Shell of an Cyclone

Analysis of wind load on large hyperbolic cooling tower considering interactionbetween internal and external pressure

Numerical investigation and optimum design of complex thin-walled structures subject to internal pressure load

Stress Analysis of Ellipsoidal Head with Heating Spiral

Structure Optimization Research Based on Numerical Simulation of Flow Field in Ammonia-Based Wet Sintering Flue Gas Desulfurization

Theoretical and numerical investigations of swirl enhanced short natural draft dry cooling towers

Computational fluid dynamics numerical simulation of flue gas emission from stack and tower integration system of coal-fired power plant

Thermal stress analysis and structural optimization of ladle nozzle based on finite element simulation

Shakedown Analysis of a Torispherical Head with a Piping Nozzle under Combined Loads by the Stress Compensation Method

FEM Analysis on Thermal Stress of Desulphurization Injection Lance

Finite Element Analysis of a Steel-tube Torch Tower under the Action of Wind Load

Safety Evaluation for Triangular Supporting Gusset and Supporting Ring at Outside of Absorption Tower

Computation of Static and Dynamic Stresses of A Bulb Tubular Turbine

Optimization of Welding Joint Between Tower and Bottom Flange Based on Residual Stress Considerations in a Wind Turbine

Simulation and Stress Analysis of X Type Weld Joint Welding Process on Large Sphere Tank