Abstract:In order to clarify the magnetic-thermal-force changing rule of high-frequency transformers under different winding arrangements, this paper tests the magnetization and loss characteristics of nanocrystalline materials at different temperatures, and based on the magnetization and loss data, establishes a magnetic-thermal-force coupling calculation model of 15 kVA, 5 kHz nanocrystalline high-frequency transformers, and calculates and analyzes the magnetic flux density, loss and temperature rise distributions of high-frequency transformers with three different winding arrangements under no-load and short-circuit conditions, respectively. Through comparative analysis, it was found that under no-load conditions, the cross-transposition of winding has less influence on the magnetic flux of the high-frequency transformer core, but it can reduce the iron-core loss and transformer temperature rise. The cross-transposition of winding under short-circuit conditions can significantly reduce the leakage magnetic field strength of high-frequency transformers; complete cross-transposition weakens the high-frequency transformer losses and temperature rise better than partial cross-transposition. According to the winding current density and core leakage field distribution under short-circuit conditions, we calculated and analyzed the distribution of its the axial and radial electromagnetic forces. The results show that the axial electromagnetic force causes the winding to be squeezed from both ends to the middle, the radial electromagnetic force causes the primary winding to shrink inward and the secondary winding to expand outward, so cross-transposition can greatly reduce electromagnetic force and weakening the deformation of the winding. Therefore, high-frequency transformers of winding cross-transposed should be used in actual projects to reduce transformer temperature rise and improve efficiency and security. This research has theoretical significance for the multi-physical field coupling of high-frequency transformers and its structural design.

A New Method to Determine 500 kV Transformer CT Polarity

Solution of Permanent Magnet Synchronous Motors with Partition between Poles Halbach Magnet

Test Judgement Method of Strand-to-Strand Short Circuit in Power Transformer Windings

The Numerical Simulation Method of Transformer Internal Short-Circuit Fault

Calculation Method of Winding Eddy-Current Losses for High-Voltage Direct Current Converter Transformers

On-line Demagnetization Method for an Iron Core CT

Dynamic Electromagnetic Force Analysis of a Power Transformer with Regulated Windings

Magnetic state balance technology of transformer based on magnetic field modulation strategy

Study on the differential protection of busbar with magnetic restraint

A Novel Method for Current Transformer Saturation Countermeasure Based on Comparing Two Currents' Polarities

A Method Based on Measured Boundary Conditions for Reconstructing the Magnetic Field Distribution of an Electromagnetic Mechatronic System

MAGNETIC RESTRAINING DIFFERENTIAL BUS PROTECT

A Versatile Analytical Method of Investigating MMF Harmonics of Armature Windings.

Numerical Investigations for Vibration and Deformation of Power Transformer Windings under Short-Circuit Condition

Vibration characteristic analysis of transformers influenced by DC bias based on vibration half-wave energy method

Testing of High Current Transformer by Non-Uniform Equivalent Magnetomotive Force Method

Analytic Calculation and Analysis of the Magnetic Field for the Single-Phase Two-Limb Transformer

Comprehensive Analysis of Electric Field Characteristics for Multi-Winding Medium Frequency Transformer

Characteristic Extraction and Assessment Methods for Transformers DC Bias Caused by Metro Stray Currents

Research on Magnetic-Thermal-Force Multi-Physical Field Coupling of a High-Frequency Transformer with Different Winding Arrangements

Analysis on eccentric bus-bar testing method of heavy current transformer