Abstract:EDA-Cu based electrochemically mediated CO2 capture method was developed as a promising technology to substitute the conventional amine-based CO2 capture, especially in industries without available steam source. However, the highly corrosive and poor Cu cycling performance seriously obstruct its large-scale application. In this work, traditional primary amine, secondary amine and tertiary amine (MEA, DEA and TEA) are chosen to blend with EDA to alleviate the problems of EDA. Electrochemical measurements, corrosiveness comparison, CO2 absorption and desorption performance were conducted to investigate the advance performance of proposed blended solvents comprehensively. The corrosion potential in all the mixtures is significantly higher than that in sole EDA solution, which illustrates that the corrosiveness of proposed mixed solvents to Cu electrode is weaker. Besides, the Cu cycling performance is greatly improved and the energy consumption is significantly reduced by using blended solvents. Overall, 50/50 EDA/MEA mixed solution with high CO2 capacity and fast absorption rate is suggested to be a substitute for traditional EDA solvent. The CO2 desorption energy consumption of 50/50 EDA/MEA mixed solution decreases 14% than that of EDA solution at a current density of 0.01 A/cm2. Meanwhile, the copper cycling performance is also improved in 50/50 EDA/MEA mixed solution as the cathode Faraday efficiency (CFE) increased from 43% (EDA) to 53% (50/50 EDA/MEA). Results show that the proposed mixed amine solvents lead to the successful circumvention of highly corrosive and poor Cu cycling performance in the electrochemically mediated CO2 capture system, which will contribute to the exploration of efficient blended solvents for EMAR CO2 capture process and promote its industrial application.

Study on Corrosion in CO2 Chemical Absorption Process Using Amine Solution

Study on CO2 Absorption-Mineralization Characteristics of Mixed Amine Solution Coupled with CaO and Key Influencing Factors in Mineralization Process

Corrosion Behavior of Carbon Steel in Diethylenetriamine Solution for Post-combustion CO2 Capture.

Absorber Corrosion Performance for CO_2 Capture Using an Amine Absorbant in a Coal-Fired Power Plant

Corrosion Performance of Carbon/stainless Steel in Amine‐based Solvents under Different Conditions for CO2 Chemical Absorption Process

Corrosion Performance of A3 Carbon Steel in 30wt.% Mea and Amp-Mea Blends for Post-Combustion Carbon Capture: Effect and Mechanism of Corrosion Inhibitors

Corrosion Behavior of Carbon Steel at Typical Positions of an Amine-Based CO2 Capture Pilot Plant

Experimental Study of Corrosion on A36 Mild Steel Towards Aqueous 2-Amino-2-Ethyl-1, 3-Propanediol and Diethanolamine

Phase-changing Solution PZ/DMF for Efficient CO2 Capture and Low Corrosiveness to Carbon Steel

Corrosion behavior of carbon steel in H2S-CO2-H2O-methyldiethanolamine (MDEA) solution under the presence of chloride ions

A Study of Designer Amine 4-Amino-1-propyl-piperidine Against the Corrosion of Carbon Steel for Application in CO2 Capture

Corrosion Mechanism of Steels in MDEA Solution and Material Selection of the Desulfurizing Equipment

Corrosion and degradation performance of novel absorbent for CO2 capture in pilot-scale

Investigation on the Performance of EDA-based Blended Solvents for Electrochemically Mediated CO2 Capture

Absorption of carbon dioxide by methyldiethanolamine/piperazine and aqueous ammonia

Experimental Study on a New High-Efficiency Aqueous Solvent Based on a Blend of N-MethyDiEthanolAmine and TriEthylene TetrAmine for the CO2 Capture

Experimental Study of Absorption Solution of CO2 Sequestration Using Chemical Absorption

Effect of Cl− Accumulation on Corrosion Behavior of Steels in H2S/CO2 Methyldiethanolamine (MDEA) Gas Sweetening Aqueous Solution

Simulation and Analysis of Carbon Dioxide Capture Process with Split Flow Modification Using MDEA/PZ Blend Solution in a Coal-fired Power Plant

Comparative Techno-Economic Analysis of CO2 Capture Processes Using Blended Amines

Study on absorption of CO2 into aqueous N-methyldiethanolamine