Abstract:Post-combustion carbon capture using amine-based adsorbents is a highly competitive approach to control CO2 emissions from fossil fuel-fired power plants. However, it is well known that amine-based adsorbents suffer from long-term stability issues due to amine poisoning by flue gas contaminants. Minor contaminants, such as SO2, can preferably react with amine sites to form irreversible sulfonamides. This work investigated the effect of nitrates on the SO2 resistance of tetraethylenepentammonium nitrate protic ionic liquid-functionalized SBA-15 for CO2 capture. The tetraethylenepentamine-functionalized SBA-15 without nitrates was prepared as the control. The CO2 adsorption capacity was measured over multiple capture cycles in the presence of 500 ppm SO2. The CO2 capture capacities of the sorbent without nitrates decreased by 1.48 mmol g(-1) (50.3%) over 11 capture cycles. After introducing nitrates into the sorbent, the CO2 adsorption capacities only decreased by 0.55 mmol g(-1) (21.8%). In addition, the nitrates restricted the reaction between amine groups and SO2 leading to reversible sulfonamide products. The significant improvement in SO2 resistance was further explained with density functional theory (DFT) calculations, which revealed that the binding energy and net charge transfer between SO2 and amine groups were decreased after introducing the nitrate group into the amine. To further investigate the regenerability and structural stability of tetraethylenepentammonium nitrate-functionalized SBA-15 for CO(2 )capture under realistic conditions, the long-term operating performance was evaluated in a gas mixture of 150 ppm SO2, 150 ppm NO, 100% RH, 15% CO2, and balance N-2. The CO2 adsorption capacities and the structural properties of nitrate-containing sorbents were nearly unchanged over eight adsorption/regeneration cycles.

Corrosion and degradation performance of novel absorbent for CO2 capture in pilot-scale

Absorber Corrosion Performance for CO_2 Capture Using an Amine Absorbant in a Coal-Fired Power Plant

Corrosion Behavior of Carbon Steel at Typical Positions of an Amine-Based CO2 Capture Pilot Plant

Experimental study on the influence of SO2 on the CO2 capture process

Pilot-Scale Experimental Study on the CO2 Capture Process with Existing of SO2: Degradation, Reaction Rate, and Mass Transfer

Reducing Aerosol and Ammonia Emission in Post-Combustion CO2 Capture: Additives As Key Solutions

Study on CO2 Absorption-Mineralization Characteristics of Mixed Amine Solution Coupled with CaO and Key Influencing Factors in Mineralization Process

Kinetic Analysis of an Anion Exchange Absorbent for Co2 Capture from Ambient Air

Enhanced Tolerance to Flue Gas Contaminants on Carbon Dioxide Capture Using Amine-Functionalized Multiwalled Carbon Nanotubes

Study on Corrosion in CO2 Chemical Absorption Process Using Amine Solution

Carbon dioxide capture by functionalized solid amine sorbents with simulated flue gas conditions.

Degradation characteristics and utilization strategies of a covalent bonded resin-based solid amine during capturing CO 2 from flue gas

Investigation of Thermal Stability and Continuous CO2 Capture from Flue Gases with Supported Amine Sorbent

Corrosion Behavior of Carbon Steel in Diethylenetriamine Solution for Post-combustion CO2 Capture.

Corrosion Performance of Carbon/stainless Steel in Amine‐based Solvents under Different Conditions for CO2 Chemical Absorption Process

Enhanced SO2 resistance of tetraethylenepentammonium nitrate protic ionic liquid functionalized SBA-15 during CO2 capture from flue gas

Post-Combustion CO2 Capture Demonstration Using Supported Amine Sorbents: Design and Evaluation of 200 Kwth Pilot

Development and testing of a new post-combustion CO2 capture solvent in pilot and demonstration plant

Corrosion Performance of A3 Carbon Steel in 30wt.% Mea and Amp-Mea Blends for Post-Combustion Carbon Capture: Effect and Mechanism of Corrosion Inhibitors

Experimental Study and Numerical Simulation on CO2 Capture from Flue Gas Using Amine-Based Absorbent in Coal-Fired Power Plant

Feasibility of CO2 Capture from O2-Containing Flue Gas Using a Poly(ethylenimine)-Functionalized Sorbent: Oxidative Stability in Long-Term Operation