Abstract:The global warming and greenhouse effect are increasingly severe. China is the world's largest CO2 emitter and is facing tremendous pressure to reduce CO2 emission. Analyses of CO2 emission sources in China show that coal-fired power plants, cement plants and steel mills make up the vast majority of CO2 emissions. Therefore, it is important to reduce CO2 emissions in the three industries. In order to reduce the capture cost we propose high salt effluent from the enterprise to absorb CO2. CO2 can be fixed in carbonates with Ca 2+ and Mg 2+ in high salt effluent. CO2 capture by high salt effluent can reach the combination of CO2 capture and storage. There are many steel industries in China. A large amount of slag waste is produced every year and heavy accumulation causes environmental pollution and waste of land resources. The slag with rich alkaline substances can be reinforce CO2 capture by high salt effluent. and carbonate product can be used as raw material for other industries. It achieve resource utilization of steel slag and the combination of CO2 capture and storage, and use waste to treat waste. On-line chromatography method is applied to determine the CO2 solubility in high salt effluent (simulated system) without and with steel slag (simulated system). It is studied on the influence of temperature and salinity on CO2 capture by high salt effluent and found the increase of temperature and salinity adverse to CO2 capture by high salt effluent. It is also studied on the influence of temperature, steel slag concentration, steel slag composition and their synergy on CO2 capture by high salt effluent with steel slag and found the decrease of temperature and the increase of slag concentration favor to CO2 capture, and CaO, MgO and their synergy all promote CO2 capture. Relative to temperature and salinity, the increasing concentration of steel slag has greatly promoted CO2 capture by high salt effluent, and CO2 solubility increases by 1115.56% per 1% increase in steel slag concentration. The thermodynamic model is built to study on CO2 capture by high salt effluent without and with steel slag and the average errors between calculation values and experimental values are less than 5% and explain the experimental results. The influence of temperature and salinity on CO2 capture are achieved by Henry’s constant and ionization constant. The increase of steel slag enhances the alkalinity of the solution and increases the concentration of H2CO3, HCO3 , CO3 2and improves the formation of carbonate, which promotes CO2 capture. CaO and MgO can promote CO2 capture because of high solubility in seawater and MgO is better than CaO in CO2 capture and Fe2O3 and Al2O3 have little effect on CO2 capture because of low solubility in high salt effluent. The kinetics of CO2 absorption in high salt effluent without and with steel slag was studied. The mass transfer coefficient decreases with decrease of pressure and pH. The increase of temperature, decrease of salinity and increase of slag concentration can increase mass transfer coefficient and promote CO2 absorption rate. In composition of steel slag, Fe2O3 can increase CO2 absorption rate. Finally, the process of CO2 capture by high salt effluent without and with steel slag were built by Aspen Plus. The effluence of temperature, pressure, liquid-gas ratio, seawater salinity, solid-gas ratio (i.e. the added quantity of steel slag) on CO2 absorptivity were studied. Optimal conditions were determined to consist of a liquid–gas ratio of 250-280, an absorber temperature of 27–32°C, an absorber pressure of 1–1.5 atm and a steel slag to gas ratio of 0.09-0.10 for ensuring CO2 absorption capacity above 90%. Two-third of CO2 was captured and stored in calcium carbonate form. Then the energy consumption and cost in the process were analyzed to be 1.017GJ/tCO2 and 76.29RMB/tCO2, respectively. Compare to other absorption processes, this process has lowest system cost.

Development of Carbon Capture Absorbents for Top Gas Recycling-Oxygen Blast Furnace in the Steel Industry

Study on CO2 Absorption-Mineralization Characteristics of Mixed Amine Solution Coupled with CaO and Key Influencing Factors in Mineralization Process

Comparative Techno-Economic Analysis of CO2 Capture Processes Using Blended Amines

Novel Tri-Solvent Amines Absorption for Flue Gas CO2 Capture: Efficient Absorption and Regeneration with Low Energy Consumption

Research on Integrated CO2 Absorption-Mineralization and Regeneration of Absorbent Process

Highly efficient CO2 capture with simultaneous iron and CaO recycling for the iron and steel industry

Capture CO2 using Steel Slag combined with high salt effluent

Process simulation, optimization and assessment of post-combustion carbon dioxide capture with piperazine-activated blended absorbents

Nonaqueous MEA/PEG200 Absorbent with High Efficiency and Low Energy Consumption for CO2 Capture

Technical and Economic Assessment of Iron and Steelmaking Decarbonization Via Power to Gas and Amine Scrubbing

Metal-Mediated, Electrochemical Absorbent Regeneration in Post-Combustion CO 2 Capture: Towards Practical Application

Multistage Circulation Absorption Improvement: Simulation and Energy-Saving Evaluation of an Innovative Amine-Based CO2 Capture Process

Carbon dioxide mineralization for the disposition of blast-furnace slag: reaction intensification using NaCl solutions: Original Research Article: Carbon dioxide mineralization for the disposition of blast-furnace slag

Catalytic regeneration of amine-based absorbents for CO 2 capture: The effect of acidic sites and accessibility

Energy Efficient Absorbents For Industry Promising Carbon Dioxide Capture

Promotion of CO2 capture performance using piperazine (PZ) and diethylenetriamine (DETA) bi-solvent blends: Original Research Article: Promotion of CO2 capture performance using PZ and DETA bi-solvent blends

Co-treatment of Waste From Steelmaking Processes: Steel Slag-Based Carbon Capture and Storage by Mineralization

Multiscale energy reduction of amine-based absorbent SO 2 capture technology: Absorbent screening and process improvement

An efficient molten steel slag gas quenching process: Integrating carbon solidification and waste heat recovery

Multi-stage Solvent Circulation Absorption Enhancement: System Optimization for Energy-Saving CO2 Capture

Corrosion Performance of A3 Carbon Steel in 30wt.% Mea and Amp-Mea Blends for Post-Combustion Carbon Capture: Effect and Mechanism of Corrosion Inhibitors