Abstract:Fracture tests are a necessary means to obtain the fracture properties of concrete, which are crucial material parameters for the fracture analysis of concrete structures. This study aims to fill the gap of insufficient test results on the fracture toughness of widely used ordinary C40~C60 concrete. A three-point bending fracture test was conducted on 28 plain concrete and 6 reinforced concrete single-edge notched beam specimens with various depths of prefabricated notches. The results are reported, including the failure pattern, crack initiation load, peak load, and complete load versus crack mouth opening displacement curves. The cracking load showed significant variation due to differences in notch prefabrication and aggregate distribution, while the peak load decreased nonlinearly with an increase in the notch-to-height ratio. The reinforced concrete beams showed a significantly higher peak load than the plain concrete beams, attributed to the restraint of steel reinforcement, but the measured cracking load was comparable. A compliance versus notch-to-height ratio curve was derived for future applications, such as estimating crack length in crack growth rate tests. Finally, fracture toughness was determined based on the double-K fracture model and the boundary effect model. The average fracture toughness value for C50 concrete from this study was 2.0 , slightly smaller than that of lower-strength concrete, indicating the strength and ductility dependency of concrete fracture toughness. The fracture toughness calculated from the two models is consistent, and both methods employ a closed-form solution and are practical to use. The derived fracture toughness was insensitive to the discrete parameters in the boundary effect model. The insights gained from this study significantly contribute to our understanding of the fracture toughness properties of ordinary structural concrete, highlighting its potential to shape future studies and applications in the field.

Fracture process zone of notched three-point-bending concrete beams

Mixed-Mode I-II Fracture Process Zone Characteristic of the Four-Point Shearing Concrete Beam

Dynamic Fracture Catastrophe Model of Concrete Beam under Static Load

Numerical simulation of cracking of early-age concrete three-point beams

Mesoscale fracture analysis of three-point bending concrete beams based on cohesive zone model

Experimental Study on the Fracture Process Zone Characteristics in Concrete Utilizing DIC and AE Methods

In-depth Analysis of Notched 3-P-b Concrete Fracture

Effects Of Notch Geometry On The Local Cleavage Fracture Stress Sigma(F)

Variation of Fracture Energy Dissipation along Evolving Fracture Process Zones in Concrete

Modelling fracture process zone width and length for quasi-brittle fracture of rock, concrete and ceramics

Fracture process zone of autoclaved aerated concrete

Fracture Toughness of Ordinary Plain Concrete Under Three-Point Bending Based on Double-K and Boundary Effect Fracture Models

Fracture Property of Steel Fiber Reinforced Concrete at Early Age

Nonlinear Fracture Analysis of Delamination Crack Jumps in Laminated Composites

Determination of Concrete Fracture Parameters from a Three-Point Bending Test

Mesoscale modelling on the evolution of the fracture process zone in concrete using a unified phase-field approach: size effect study

Crack Extension Resistance and Fracture Properties of Quasi-Brittle Softening Materials like Concrete Based on the Complete Process of Fracture

Meso-scale modelling of the size effect on the fracture process zone of concrete

Influence of Mineral Admixture on Early-Age Concrete Cracking

Experimental verification and simulation of fracture behavior of CFRP reinforced self-consolidating concrete beams with initial notch

Fracturing behaviors of FRP-strengthened concrete structures