Abstract:Fracture tests are a necessary means to obtain the fracture properties of concrete, which are crucial material parameters for the fracture analysis of concrete structures. This study aims to fill the gap of insufficient test results on the fracture toughness of widely used ordinary C40~C60 concrete. A three-point bending fracture test was conducted on 28 plain concrete and 6 reinforced concrete single-edge notched beam specimens with various depths of prefabricated notches. The results are reported, including the failure pattern, crack initiation load, peak load, and complete load versus crack mouth opening displacement curves. The cracking load showed significant variation due to differences in notch prefabrication and aggregate distribution, while the peak load decreased nonlinearly with an increase in the notch-to-height ratio. The reinforced concrete beams showed a significantly higher peak load than the plain concrete beams, attributed to the restraint of steel reinforcement, but the measured cracking load was comparable. A compliance versus notch-to-height ratio curve was derived for future applications, such as estimating crack length in crack growth rate tests. Finally, fracture toughness was determined based on the double-K fracture model and the boundary effect model. The average fracture toughness value for C50 concrete from this study was 2.0 , slightly smaller than that of lower-strength concrete, indicating the strength and ductility dependency of concrete fracture toughness. The fracture toughness calculated from the two models is consistent, and both methods employ a closed-form solution and are practical to use. The derived fracture toughness was insensitive to the discrete parameters in the boundary effect model. The insights gained from this study significantly contribute to our understanding of the fracture toughness properties of ordinary structural concrete, highlighting its potential to shape future studies and applications in the field.

Dynamic Fracture Catastrophe Model of Concrete Beam under Static Load

Stochastic Fracture of Concrete Composites: A Mesoscale Methodology

Uniaxial Concrete Tension Damage Evolution Using Acoustic Emission Monitoring

Cohesive Cracking Simulation of Concrete Using Effective Modulus

Numerical simulation of cracking of early-age concrete three-point beams

Numerical Simulation of Fracture and Damage Behaviour of Concrete at Different Ages

New concrete cracking model established based on fracture mechanics and damage theory

A Mesoscale Modelling Approach Coupling SBFEM, Continuous Damage Phase-Field Model and Discrete Cohesive Crack Model for Concrete Fracture

To Monitor Fracture Behaviors in Four-Point Cyclic Bending Tests of Low-Activated High Alumina Concrete and Standard Concrete RC Beams Using Acoustic Emission Technique

Mesoscale fracture analysis of three-point bending concrete beams based on cohesive zone model

3 D In-situ XCT Image Based Mesoscale Fracture Modelling and Validation of Concrete Using Voxel Hexahedron Meshing and Damage Plasticity Model

Research and Application of Random Aggregate Model in Determining the Fracture Behavior of Four-Point Bending Beam with Notch

Experimental study on acoustic emission and surface morphology characteristics of concrete under different fracture modes

Parametric analysis of dynamic crack propagation of concrete bending beam based on the extended finite element method

Modelling damage mechanisms of concrete under high confinement pressure

3D Mesoscale Fracture Analysis of Concrete under Complex Loading

Fracture Toughness of Ordinary Plain Concrete Under Three-Point Bending Based on Double-K and Boundary Effect Fracture Models

Dynamic Model of Fracture Normal Behaviour and Application to Prediction of Stress Wave Attenuation Across Fractures

Three-dimensional Nonlinear Numerical Model for Concrete Fracture Analysis

FRACTURE CHARACTERISTICS OF CONCRETE STRUCTURES USING SUB-DOMAIN BOUNDARY ELEMENT METHOD

Simulation of Meso-Fracture for Concrete Based on the Developed Random Aggregate Model