Abstract:Spectral emissivity is one of the most critical thermophysical properties of a material for heat design and analysis. Especially in the traditional radiation thermometry, normal spectral emissivity is very important. We developed a prototype instrument based upon an integral blackbody method to measure material's spectral emissivity at elevated temperatures. An optimized commercial variable-high-temperature blackbody, a high speed linear actuator, a linear pyrometer, and an in-house designed synchronization circuit was used to implemented the system. A sample was placed in a crucible at the bottom of the blackbody furnace, by which the sample and the tube formed a simulated reference blackbody which had an effective total emissivity greater than 0.985. During the measurement, a pneumatic cylinder pushed a graphite rode and then the sample crucible to the cold opening within hundreds of microseconds. The linear pyrometer was used to monitor the brightness temperature of the sample surface, and the corresponding opto-converted voltage was fed and recorded by a digital multimeter. To evaluate the temperature drop of the sample along the pushing process, a physical model was proposed. The tube was discretized into several isothermal cylindrical rings, and the temperature of each ring was measurement. View factors between sample and rings were utilized. Then, the actual surface temperature of the sample at the end opening was obtained. Taking advantages of the above measured voltage signal and the calculated actual temperature, normal spectral emissivity under the that temperature point was obtained. Graphite sample at 1300 degrees C was measured to prove the validity of the method.

Measurement of Thermophysical Properties by a Pulse-Heating Technique: (1100 K to the Melting Point)

Mathematical Model of Strip Specimens for Application of Pulse-Heating Technique

Reviews of Pulse-heating Technique for Thermophysical Properties Measurement

Thermal Characterization of Microscale Conductive and Nonconductive Wires Using Transient Electrothermal Technique

Invited Article: Micron Resolution Spatially Resolved Measurement of Heat Capacity Using Dual-Frequency Time-Domain Thermoreflectance.

Applications of High-speed Pyrometer to the Pulse Heating Methods

Temperature measurement during rapid solidification

Development of a Millisecond Pulse-Heating Apparatus

Dynamic Measurement of Normal Spectral Emissivity (at 905nm) by a Pulse-Heating Reflectometric Technique

Thermal Conductivity Measurement from 30 to 750 K: the 3ω Method

Photothermal phenomenon: Extended ideas for thermophysical properties characterization

Research on the Data Processing Multispectral Method of Melting Point Temperature and Normal Spectral Emissivities

Measurement of Thermophysical Properties of Niobium by Pulse-Heating Method

A Measuring System for Carbon-Carbon Composite Thermal Physical Properties at High Temperature

A Multiwavelength Reflectometric Technique for Normal Spectral Emissivity Measurements by a Pulse-Heating Method

Measurement of High-Temperature Spectral Emissivity Using Integral Blackbody Approach

A New Thermal Property Measurement Technique by Modified Pattern Search Method

Investigation on the New Methods for Dynamic Measurement of Thermophysical Properties of Metals and Alloys at the Melting Point

Selection of Heating Power in Thermophysical Property Measurement with Transient Hot-strip Method

Simultaneous Measurement of Thermal Conductivity and Heat Capacity Across Diverse Materials Using the Square-Pulsed Source (SPS) Technique

A Novel Method for Determining the Melting Point, Fusion Latent Heat, Specific Heat Capacity and Thermal Conductivity of Phase Change Materials