Abstract:A visible-infrared multispectral synchronous imaging pyrometer was developed for simultaneous, multispectral, two-dimensional high temperature measurements. The multispectral image pyrometer uses prism separation construction in the spectrum range of 650–950 nm and multi-sensor fusion of three CCD sensors for high-temperature measurements. The pyrometer had 650–750 nm, 750–850 nm, and 850–950 nm channels all with the same optical path. The wavelength choice for each channel is flexible with three center wavelengths (700 nm, 810 nm, and 920 nm) with a full width at half maximum of the spectrum of 3 nm used here. The three image sensors were precisely aligned to avoid spectrum artifacts by micro-mechanical adjustments of the sensors relative to each other to position them within a quarter pixel of each other. The pyrometer was calibrated with the standard blackbody source, and the temperature measurement uncertainty was within 0.21 °C–0.99 °C in the temperatures of 600 °C–1800 °C for the blackbody measurements. The pyrometer was then used to measure the leading edge temperatures of a ceramics model exposed to high-enthalpy plasma aerodynamic heating environment to verify the system applicability. The measured temperature ranges are 701–991 °C, 701–1134 °C, and 701–834 °C at the heating transient, steady state, and cooling transient times. A significant temperature gradient (170 °C/mm) was observed away from the leading edge facing the plasma jet during the steady state heating time. The temperature non-uniformity on the surface occurs during the entire aerodynamic heating process. However, the temperature distribution becomes more uniform after the heater is shut down and the experimental model is naturally cooled. This result shows that the multispectral simultaneous image measurement mode provides a wider temperature range for one imaging measurement of high spatial temperature gradients in transient applications.

Temperature measurement during rapid solidification

A Sapphire Fiber Thermometer for High Temperature Measurement in Tundish Based on the Fast Fourier Transform

Thermal Conductivity Measurement from 30 to 750 K: the 3ω Method

A high-speed, eight-wavelength visible light-infrared pyrometer for shock physics experiments

Non-Contact Temperature Measurement by Infrared Pyrometer in High Speed Milling

Spectral Pyrometry for Practical Temperature Measurement in the TEM

VIS-NIR Multispectral Synchronous Imaging Pyrometer for High-Temperature Measurements.

Measurement of Thermophysical Properties by a Pulse-Heating Technique: (1100 K to the Melting Point)

Fast Multi-Wavelength Pyrometer for Dynamic Temperature Measurements

A novel multi-band plenoptic pyrometer for high-temperature applications

Temperature measurements using multicolor pyrometry in thermal radiation heating environments.

Miniature Uncooled and Unchopped Fiber Optic Infrared Thermometer for Application to Cutting Tool Temperature Measurement

Ultrasonic thermometric measurement system for solid rocket combustion chambers

Measurement Of Solid-Liquid Interface Temperature During Pulsed Excimer-Laser Melting Of Polycrystalline Silicon Films

A Wide-Range Multi-Spectral Pyrometer For True Temperature Measurement Of Solid Rocket Engine Plume

Development of A Multi-Spectral Pyrometry Sensor for High-Speed Transient Surface-Temperature Measurements in Combustion-Relevant Harsh Environments

Measurement of High-Temperature Spectral Emissivity Using Integral Blackbody Approach

Development of a New Fiber-Optic Multi-Target Multispectral Pyrometer for Achievable True Temperature Measurement of the Solid Rocket Motor Plume

High Temperature Measurement Up to 1100 $^{\circ} \hbox{c}$ Using a Polarization-Maintaining Photonic Crystal Fiber

Cutting temperature measurement using an improved two-color infrared thermometer in turning Inconel 718 with whisker-reinforced ceramic tools

Cutting Temperature Measurement Using a Novel Near-Infrared Two-Color Pyrometer under Dry and Wet Cutting of Ti‐6Al‐4V Alloy