Abstract:This study proposes a high-speed (∼500 Hz), non-intrusive ultrasonic-based temperature measurement method and investigate its performance characteristics by conducting a static behavior measurement at ambient temperature and a dynamic behavior measurement from ambient temperature to 700 °C. In the ambient-temperature experiment, the optimal design of the ultrasonic wave propagation tube is verified by comparing the collected signal intensities. The high repeatability of the ultrasonic wave measurement method is verified with Pearson correlation coefficients of over 99.96 % among the received raw ultrasonic wave signals for every 0.002 s. In the dynamic high-temperature experiment, the measurement accuracy is validated by comparing the temperature deviation from the thermocouple temperature. In the fast-rising low-temperature region around 25–100 °C, a high error rate (>100 %) is obtained; therefore, a signal-denoising algorithm and four candidates of post-processing equations are applied to improve the ultrasonic wave thermometry accuracy. In the four candidate equations, the optimal post-processing method is determined to be the one that yields a linear fitting with slope and intercept obtained in Kelvin temperature. The accuracy of ultrasonic wave thermometry is verified with the time-weighted average and standard deviation of error rates being 1.09 % and 1.10 %, respectively, significantly lower than those of typical commercial thermocouples . As ultrasonic wave thermometry can only perform line-integral measurement and not point measurement, it can be effective for anomaly detection of steady operating systems like gas turbines and boilers for power generation. Thus, fast-responsive, line-integral ultrasonic wave thermometry can be a diagnostic tool to reduce the risk of combustion instability accidents or other problems caused by rapid temperature change.

Ultrasonic thermometric measurement system for solid rocket combustion chambers

A Wide-Range Multi-Spectral Pyrometer For True Temperature Measurement Of Solid Rocket Engine Plume

The Measurement and Analysis of Temperature Field in a Solid Motor Nozzle Throat Insert

Temperature measurement during rapid solidification

Combustion Gas Temperature Measurement in the Chamber of Solid Rocket Motor by Double Line of Atomic Emission Spectroscopy

Heat Flux Measurement Method of Two-Phase Flow in SRM

Experimental detection of two-dimensional temperature distribution in Rocket-Based Combined Cycle combustion chamber using multispectral imaging processing

A Two-Wavelength Optical Method for the High Combustion Temperature Measurement of Solid Propellant

High Temperature Measurement of Combustion Gas in Solid Rocket Motor Utilizing Alexandrite Effect

Research on key technology of ultrasonic temperature measuring instrument in high-temperature solid structure

Plume Temperature Measurement of a Solid Propellant Rocket Engine Using Multispectral Thermometry

Development of a New Fiber-Optic Multi-Target Multispectral Pyrometer for Achievable True Temperature Measurement of the Solid Rocket Motor Plume

Simulated Experiment on Case Overheating Failure of Solid Rocket Motor under Flight Overload Condition

Ito Thin Film Thermocouple For Transient High Temperature Measurement In Scramjet Combustor

A Real-time Temperature Measurement Device for Rocket Propellant

Development of a Special Multi-Wavelength Pyrometer for Temperature Distribution Measurements in Rocket Engines

Development of multi-target multi-spectral high-speed pyrometer

On-Line Combustion Temperature Measurements of Solid Rocket Propellant by Using Radiation Spectroscopy

Experimental investigation on the measurement performance of high-speed ultrasonic wave thermometry in ambient- and high-temperature environments

Experimental Method Research on Ablation Characteristic of Insulation Material under High Temperature Alumina Droplet Deposition Condition

Synchronous Measurement of Temperature and Deformation by an Ultraviolet Imaging System and Monochromatic Pyrometry at Extreme Temperatures