Abstract:Thermal insulation materials are widely used in the fields of thermal protection and the energy conservation at high temperature. Thermal conductivity is one of the most important parameters of characterizing the thermal insulation performance of thermal protection materials. Steady state method such as the guarded hot plate method is normally considered as the most accurate method to measure the thermal conductivity of thermal insulation materials, but the temperature range is limited to below 1000 K. Unsteady state method can be employed at higher temperature but the accuracy is lacking of validation. Consequently, thermal verification experiments are usually conducted by heating the front surface of thermal insulation materials to a very high temperature. However, it is difficult to obtain the temperature-dependent thermal conductivity by using the thermal insulation performance measured with a large temperature difference across the material. In this study, a sandwich structure experimental system is built to carry out the thermal insulation performance tests with a large temperature difference at both steady state and transient state. Both uniform temperature layer method and polynomial fitting method are adopted to extract the temperature-dependent thermal conductivity from the large temperature difference test at steady state. A new transient state identification method is proposed based on the niche genetic algorithm to identify the relation between thermal conductivity and temperature from the transient thermal response. The temperature-dependent thermal conductivity of four thermal protection materials are finally obtained. The identification results prove that the proposed transient identification method is reliable and robust.

Selection of Heating Power in Thermophysical Property Measurement with Transient Hot-strip Method

Thermal conductivity measurement of phase-change material near melting point based on perturbation method

Thermal Characterization of Microscale Conductive and Nonconductive Wires Using Transient Electrothermal Technique

Theoretical and Experimental Study on Transient Measurement of Wood Thermal Properties

Influence of Participating Radiation on Measuring Thermal Conductivity of Translucent Thermal Insulation Materials with Hot Strip Method

Numerical Study of the Influence of Thermal Radiation on Measuring Semi-Transparent Thermal Insulation Material with Hot Wire Method

Experimental study on measurement accuracy of hot disk thermal constants analyser

Short Hot Wire Technique for Measuring Thermal Conductivity and Thermal Diffusivity of Various Materials

Automatic Algorithm Applied for Calculating Thermal Conductivity by Transient Plane Source Method

Long Short Hot-Probe Method for Determining Thermophysical Properties

Analysis on the Influencing Factor of Stable Flat Measuring Method for Thermal Conductivity Measurement

Measurement and identification of temperature-dependent thermal conductivity for thermal insulation materials under large temperature difference

Simultaneous measurements of the specific heat and thermal conductivity of suspended thin samples by transient electrothermal method.

Influence Factors Analysis of Thermal Conductivity Measurement with Hot Disk Technique

Measurement of Thermophysical Properties by a Pulse-Heating Technique: (1100 K to the Melting Point)

A New Thermal Property Measurement Technique by Modified Pattern Search Method

Invited Article: Micron Resolution Spatially Resolved Measurement of Heat Capacity Using Dual-Frequency Time-Domain Thermoreflectance.

The Principle To Measure Thermal Conductivity By A New Thermal Probe Method

The method and application of thermal diffusivity measurement of materials by transient method

Thermophysical Property Measurement of Thermal Protective Material by Guarded Plane Source Method

Mathematical Model of Strip Specimens for Application of Pulse-Heating Technique