Abstract:This work was focused on revealing the relation between the microstructure and corrosion dynamics in dilute Mg97.94Zn0.56Y1.5 (at.%) alloys prepared by the consolidation of rapidly solidified (RS) ribbons. The dynamics of the corrosion were followed by common electrochemical methods and the acoustic emission (AE) technique. AE monitoring offers instantaneous feedback on changes in the dynamics and mode of the corrosion. In contrast, the electrochemical measurements were performed on the specimens, which had already been immersed in the solution for a pre-defined time. Thus, some short-term corrosion processes could remain undiscovered. Obtained results were completed by scanning electron microscopy, including analysis of a cross-section of the corrosion layer. It was shown that the internal strain distribution, the grain morphology, and the distribution of the secondary phases play a significant role in the corrosion. The alloys are characterized by a complex microstructure with elongated worked and dynamically recrystallized α-Mg grains with an average grain size of 900 nm. Moreover, the Zn- and Y-rich stacking faults (SFs) were dispersed in the grain interior. In the alloy consolidated at a lower extrusion speed, the homogeneous internal strain distribution led to uniform corrosion with a rate of 2 mm/year and a low hydrogen release. The consolidation at a higher extrusion speed resulted in the formation of uneven distribution of internal strains with remaining high strain levels in non-recrystallized grains, leading to inhomogeneous growth and breakdown of the corrosion layers. Therefore, homogeneity of the internal strain distribution is of key importance for the uniform formation of a protective layer.

Corrosion process of Mg–Sn alloys revealed via in situ synchrotron X-ray radiography

In vitro investigation on microstructure, bio-corrosion properties and cytotoxicity of as-extruded Mg–5Sn–xIn alloys

Effect of Microstructure on the Corrosion Behavior of as-cast and Extruded Mg–Sn–Y Alloys

Understanding Corrosion Mechanism of Sn–Zn Alloys in NaCl Solution Via Corrosion Products Characterization

In-situ AFM and quasi-in-situ studies for localized corrosion in Mg-9Al-1Fe-(Gd) alloys under 3.5 wt.% NaCl environment

In Vitro Corrosion Mechanism of Biodegradable Mg-Zn-Gd Alloy

Effects of SnO 2 Passive Film and Surface Micro-Galvanic Corrosion on the Corrosion Behavior of as-Extruded Mg-9Li-5Al-xSn Alloys

Comparative, Real-Time in Situ Monitoring of Galvanic Corrosion in Mg-Mg2Ca and Mg-MgZn2 Couples in Hank's Solution

The effects of Sn content on the corrosion behavior and mechanical properties of Mg–5Gd–3Y– x Sn–0.5Zr alloys

Corrosion Behavior of Pure Mg Based on Generation/Collection and Feedback Modes of Scanning Electrochemical Microscopy

Elucidating the dependence of corrosion behavior and mechanical property on the grain structure of low-temperature as-extruded Mg–Zn–Ca–Zr alloy

Microstructure and corrosion behavior of as-homogenized and as-extruded Mg−xLi−3Al−2Zn−0.5Y alloys (x=4, 8, 12)

Tailoring the corrosion behavior and mechanism of Mg-Gd-Zn alloys via Sc microalloying

Revealing the Microstructural Aspects of the Corrosion Dynamics in Rapidly Solidified Mg-Zn-Y Alloys Using the Acoustic Emission Technique

Corrosion Process Study of Zn-30Sn High-Temperature Lead-Free Solder

Investigating the corrosion behavior of as‐cast Mg‐Zn‐Ca alloys with the same Zn/Ca atomic ratio by in situ observation

Corrosion behavior and mechanical properties of extruded low-alloyed Mg−0.5Bi−0.5Y−0.2Zn alloy

Unveiling Corrosion Pathways of Sn Nanocrystals through High-Resolution Liquid Cell Electron Microscopy

Electrochemical corrosion behavior of Mg-Al-Sn alloys with different morphologies of β-Mg 17 Al 12 phase as the anodes for Mg-air batteries

Investigation of Zn alloy coating with submicron phases on magnesium alloy by the novel hot-dip process

Study of the corrosion mechanism of Mg–Gd based soluble magnesium alloys with different initial texture states