Abstract:High-energy ball milling represents an efficient process for producing composite powders consisting of ceramic particles dispersed in a metallic matrix. However, collision events, plastic deformations, and cold welding during the milling lead to a flake or block-like shape of the resulting composite powders. Further consolidation of such irregularly shaped powders by powder bed-based additive manufacturing technologies can be challenging because of their low flowability and low bulk density. In this work, different approaches, including milling process parameters (speed, process control agent atmosphere) and post-treatments (mechanical and thermal), are investigated on their suitability to influence the particle shape, especially concerning the roundness of the composite powders consisting of the aluminum alloy AlSi10Mg with 5 vol% SiC and Al2O3 reinforcement. It is found that milling with menthol as a process control agent leads to the finest composite powder compared to other milling parameters, with the lowest particle roundness of 0.39 (initial powders 0.84). No success in rounding the milled composite powder could be achieved through mechanical post-treatment in a planetary ball mill. On the other side, the thermal spraying of, e.g., SiC reinforced AlSi10Mg powder resulted in a 77–82% relative roundness. A remarkable change in the microstructure and the shape of the composite powders could also be observed after heat treatment in tube furnaces at a temperature above the melting point of AlSi10Mg. The best result in terms of improved roundness (relative to around 85%) was obtained for Al2O3 reinforced at 600 °C. A further increase of the temperature to 700 °C resulted in a moderate coarsening of powders with Al2O3 and extensive sintering of powders with SiC, presumably due to a different distribution inside the matrix.

Effect of particle morphology on the flowability of HDH Ti powders treated by high temperature ball milling

High-temperature ball milling: An efficient method to fabricate Ti and its alloy powder for additive manufacturing

Shape Modification of HDH Ti Powder and Its Mechanism Analysis

Effect of powder morphology on flowability and spreading behavior in powder bed fusion additive manufacturing process: a particle-scale modeling study

Quantitative Characterization of Metal Powder Morphology, Size Distribution, and Flowability for Additive Manufacturing

Effect of particle surface roughness on the flowability and spreadability of Haynes 230 powder during laser powder bed fusion process

Effect of ball-milling on the phase structure and hydrogen storage properties of Ti0.9Zr0.1Mn1.5 alloy

Powder flowability characterisation at preheating temperature in additive manufacturing

Influence of particle morphology and size distribution on the powder flowability and laser powder bed fusion manufacturability of Ti-6Al-4V alloy

Effects of Powder Surface Conditions on the Rheological Behavior of Ti–6Al–4 V Alloy Powders for Additive Manufacturing

Controlling factors determining flowability of powders for additive manufacturing: A combined experimental and simulation study

Comprehensive evaluation of powder flowability for additive manufacturing using principal component analysis

Investigating phase transformation, densification and diffusion mechanism of TiH 2 powder to achieve a high ductile Ti6Al4V alloy

Optimization of structures and mass transformation in TiB2-Cu FGM fabricated by SHS

Ultra-low cost Ti powder for selective laser melting additive manufacturing and superior mechanical properties associated

Characterization and flowability methods for metal powders

Study on the Flow Properties of Ti-6Al-4V Powders Prepared by Radio-Frequency Plasma Spheroidization

Effect of Material Microstructure on Tool Wear Behavior During Machining Additively Manufactured Ti6Al4V

Influence of Different Powder Conditioning Strategies on Metal Binder Jetting with Ti-6Al-4V

Influencing the Size and Shape of High-Energy Ball Milled Particle Reinforced Aluminum Alloy Powder

Effect of Alloying Powders on Microstructure and Mechanical Properties of Aluminum Alloy Arc Additive Manufacturing