Abstract:Signal detection plays a very important part in information times, which includes optical signal detection and electronic signal detection. Without question, 21 century is an optical times, so the importance of the optical signal detection becomes obvious. Optical detection includes direct detection and indirect detection (coherent detection). Direct detection is a method which only measures the amplitude of the signal and also be used in the measurement for strong signal. In contrast in indirect detection other parameters of the received electrical field can be modulated, such as its amplitude, frequency or phase. Coherent detection can be performed using two different techniques: heterodyne detection and homodyne detection. The coherent detection has much more sensitivity improvement over direct detection. However, some errors arise because of the two unstable signals, i.e., local beam and signal beam. Therefore, balanced detection technique can solve the question. In this paper, balanced detection technique was analyzed, which also was applied in signal measurement for lidar. Firstly, Mathematical modeling of the balanced detection process is deduced. Secondly, a numerical simulated system is established with software LABVIEW. Signal-to-noise ratio of the balanced detection is much two times than that of normal coherent detection technique. Furthermore, this balanced detection technique, which also be used in measurement for wind, not only Doppler shift can be obtained, but whether the Doppler shift is positive or negative can be distinguished, in other words, can know the direction of wind. Last but not least, the experiment results is well consisted with the simulated results, which shows that signal-to-noise ratio has been improved obviously.

Investigation on single-particle detection of continuous-waves coherent Doppler lidar: theoretical feasibility and performance comparison with multiple-particle detection state

Investigation of Balanced Detection and Receiver for Coherent Lidar

Theoretical performance of a 1.5-μm satellite-borne coherent Doppler wind lidar using a planar waveguide optical amplifier with a demonstrated figure of merit: simulation of signal detection probability, measurement precision, and bias

Atmospheric carbon dioxide profile detection with a continuous-wave differential absorption lidar

Design of Direct Detection Doppler Lidar with Coherent Light Path

Performance analysis of dual-frequency lidar in the detection of the complex wind field

Influence of photocurrent noise on detection performance of continuous coherent lidar

Self-homodyne coherent Lidar system for range and velocity detection

15 Μm Polarization Coherent Lidar Incorporating Time-Division Multiplexing

Application and Analysis of the Dual Fabry-Perot Etalon in a Direct Detection Wind Lidar

Numerical simulation of balanced heterodyne detection for coherent lidar

Meter-scale and Sub-Second-resolution Coherent Doppler Wind LIDAR and Hyperfine Wind Observation

All-fiber Multifunction Differential Absorption CO2 Lidar Integrating Single-Photon and Coherent Detection

Field programmable gate array-based coherent lidar employing the ordinal statistics method for fast Doppler frequency determination

Monolithic Coherent LABS Lidar Based on an Integrated Transceiver Array

Coherent Doppler Lidar for Improved Object Velocomitry using Dual Measurement Fusion

Demonstration and optimization of coherent Doppler wind LiDAR with low sampling resolution

Detection of Doppler Signal of Moving Target Using 1.06 μm Coherent Detection Lidar

1.5 mu m polarization coherent lidar incorporating time-division multiplexing

High-resolution wide range dual-channel scheimpflug lidar for aerosols detection

Hybrid Lidar System Using Combination Of Time Correlated Single Photon Counting And Waveform Sampling