Abstract:A novel Rayleigh Doppler lidar technology based on a quadruple dual-pass Fabry–Perot interferometer (FPI) that can accurately measure wind field, temperature and aerosol backscatter ratio from the troposphere to lower stratosphere is proposed. This study aims to analyse the detection principle of wind speed, temperature and aerosol backscatter ratio in detail and obtain their measurement error formulas. The structure of this type of lidar is studied and designed. The FPI consists of two edge channels FPI-1 and FPI-2, aerosol channel FPI-M and locking channel FPI-L. FPI-1, FPI-2 and FPI-M use a dual-pass optical path, whereas FPI-L uses a single-pass optical path. The parameters of FPI are optimised as follows: the free spectral spacing (FSR) is 12 GHz, the FWHM of FPI-1 and FPI-2 are both 2.2 GHz, the peak-to-peak interval of FPI-1 and FPI-2 is 5.8 GHz, the FWHM of FPI-M and FPI-L are both 1.2 GHz, the peak-to-peak interval of FPI-M and FPI-1 is 2.9 GHz and the peak-to-peak interval of FPI-L and FPI-1 is 2.3 GHz. Under simulated atmospheric conditions, for a daytime sky background brightness of 0.3 Wsr −1 m −2 nm −1 at 355 nm, using a laser with a pulse energy of 350 mJ and a repetition frequency of 50 Hz and a telescope with a 0.45-m aperture, with a vertical range resolution of 30 m at 0–10 km, 100 m at 10–20 km and 500 m at 20–35km, temporal resolution of 30 min, zenith angle of 0° for temperature and aerosol backscatter ratio detection and temporal resolution of 3 min and zenith angle of 30° for radial wind speed detection, the detection performance of the designed Rayleigh Doppler lidar is determined. The simulation results show that the measurement errors of aerosol backscatter ratio, temperature and radial wind speed of the lidar system in the daytime and night-time are less than 4.36 × 10 −3 and 3.32 × 10 −3 (excluding cirrus cloud area), 4.0 K and 3.0 K and 3.8 m/s and 1.9 m/s, respectively, from an altitude of 0.06 to 35km.

Performance validation for wind measurement with multi-longitudinal mode double-edge detection

Multi-Longitudinal-Mode High-Spectral-Resolution Lidar

Performance analysis of dual-frequency lidar in the detection of the complex wind field

Doppler Wind Lidar Based on Fabry-Perot Etalon

Design and performance simulation of 532 nm Rayleigh–Mie Doppler lidar system for 5–50 km wind measurement

Analysis of data processing method for Doppler wind lidar

Analysis on wind retrieval methods for Rayleigh Doppler lidar

Research on optimizing the optical local-oscillator power of Coherent Doppler LiDAR to enhance wind velocity measurements

Direct Detection Doppler Wind Lidar Based on Dual FP Etalon

Research on the Performance of an Active Rotating Tropospheric and Stratospheric Doppler Wind Lidar Transmitter and Receiver

1.55Μm All-Fiber Coherent Doppler Lidar for Wind Measurement

A novel wind ladar system based on 1.55 mu m All-fiber Coherent

Quad-Fabry-Perot etalon based Rayleigh Doppler lidar for 0.2-60km altitude wind, temperature and aerosol accurate measurement

Scanning Rayleigh Doppler Lidar for Wind Profiling Based on Non-polarized Beam Splitter Cube Optically Contacted FPI

Mobile Rayleigh Doppler lidar for wind and temperature measurements in the stratosphere and lower mesosphere

Wind velocity retrieval and field widening techniques of fringe-imaging Mach-Zehnder interferometer for Doppler lidar

Performance Evaluation and Error Tracing of Rotary Rayleigh Doppler Wind LiDAR

Rayleigh Doppler Lidar Technology Based on a Quadruple Dual-pass Fabry–Perot Interferometer

Performance of Continuous-wave Coherent Doppler Lidar for Wind Measurement

Scaling of the Initial Work Location in Doppler Wind Lidar

Mid-altitude wind measurements with mobile Rayleigh Doppler lidar incorporating system-level optical frequency control method