Abstract:With continuous technological development, the future development trend of LiDAR in the field of remote sensing and mapping is to obtain the elevation and spectral information of ground targets simultaneously. Airborne hyperspectral imaging LiDAR inherits the advantages of active and passive remote sensing detection. This paper presents a simulation method to determine the design parameters of an airborne hyperspectral imaging LiDAR system. In accordance with the hyperspectral imaging LiDAR equation and optical design principles, the atmospheric transmission model and the reflectance spectrum of specific ground targets are utilized. The design parameters and laser emission spectrum of the hyperspectral LiDAR system are considered, and the signal-to-noise ratio of the system is obtained through simulation. Without considering the effect of detector gain and electronic amplification on the signal-to-noise ratio, three optical fibers are coupled into a detection channel, and the power spectral density emitted by the supercontinuum laser is simulated by assuming that the signal-to-noise ratio is equal to 1. The power spectral density emitted by the laser must not be less than 15 mW/nm in the shortwave direction. During the simulation process, the design parameters of the hyperspectral LiDAR system are preliminarily demonstrated, and the feasibility of the hyperspectral imaging LiDAR system design is theoretically guaranteed in combination with the design requirements of the supercontinuum laser. The spectral resolution of a single optical fiber of the hyperspectral LiDAR system is set to 2.5 nm. In the actual prototype system, multiple optical fibers can be coupled into a detection channel in accordance with application needs to further improve the signal-to-noise ratio of hyperspectral LiDAR system detection.

Research on wavelength hopping low probability of intercept coherent LiDAR technology

Multi-Longitudinal-Mode High-Spectral-Resolution Lidar

Investigation of Anti-Interference Characteristics of Frequency-Hopping LiDAR

Research on Mode Hopping Detection of Ultra-narrow Line-width Lasers Based on the Visibility Change of Fiber Mach-Zehnder Interferometer

Hitless Two-Dimensional Focal Plane Switch Array Based on MZI-embedded MRRs

Design of a LiDAR ranging system based on dual‐frequency phase modulation

A Novel Cppm Anti-Crosstalk Collision Avoidance Lidar with Ultra-Low Laser Power

High-resolution LiDAR Using Random Modulated Continuous Wave with a Low Code Rate

A Hybrid Solid-State Beam Scanner for LiDAR Applications

SiPM-based LiDAR with multipulse sequence modulation and multithreshold signal processing

Airborne Single-Photon LiDAR Towards a Small-Sized and Low-Power Payload

High SNR signal processing system for coherent solid-state LIDAR with silicon photonic balanced photodetector array

High Resolution with Low Code Rate Random Modulation Cw Lidar for Range Imaging

Immunity to Mutual Interference in Coded Phase-Shift LiDAR

Ultra-low power anti-crosstalk collision avoidance light detection and ranging using chaotic pulse position modulation approach*

Long distance high resolution FMCW laser ranging with phase noise compensation and 2D signal processing

Parameter Simulation and Design of an Airborne Hyperspectral Imaging LiDAR System

Identity-enabled CDMA LiDAR for massively parallel ranging with a single-element receiver

Chaos single photon LIDAR and the ranging performance analysis based on Monte Carlo simulation

Remote Phase-Shift LiDAR With Communication

Long Range 3D Imaging Through Atmospheric Obscurants Using Array-Based Single-Photon LiDAR.