Abstract:Molecular dynamics simulations are performed to study the mechanical properties and deformation mechanisms of a heterogeneous face-centered cubic/ body-centered cubic Cu/Ta nanolayered composite under uniaxial tension and compression. The results show that the stress-strain curves exhibit two main yield points in tension while only one yield point during compression, and the deformation primarily experiences three stages. The first stage is linearly elastic at small strains, followed by the nucleation and propagation of dislocations and stacking faults in the Cu layers, and eventually the Ta layers yield to plastic deformation. The yield of the specimen is mainly determined by the dislocation evolution in the hard phase (i.e. Ta layers), which leads to a sharp drop in the stress-strain curve. We show that the heterogeneous nanolayered composite exhibits a good deformation compatibility during compression but an obvious deformation incompatibility between Cu and Ta layers in tension. The temperature effect is also systematically investigated. It is revealed that the yield of the specimen at higher temperature depends only on the dislocation evolution in the thick Ta layers, and the yield strengths in tension and compression both decrease with the increasing temperature. In particular, our computations show that high temperature can significantly suppress the dislocation activities in the Cu layers during deformation, which results in a lower dislocation density of the Cu layers compared with that of the Ta layers and thus causing an incompatible fashion among the constituent layers.

Effect of layer thickness on mechanical properties of Cu/CoCrFeNi nanolaminates: Implications from a quantitative flow stress model

Modeling the Strain Rate-Dependent Constitutive Behavior in Nanotwinned Polycrystalline Metals

A Molecular Dynamics Study on Mechanical Performance and Deformation Mechanisms in Nanotwinned NiCo-based Alloys with Nano-Precipitates under High Temperatures

Simulating Size and Volume Fraction-Dependent Strength and Ductility of Nanotwinned Composite Copper

Atomistic and Theoretical Insights on Nanoprecipitates-Controlled Strengthening Behavior for Optimum Mechanical Performance in Nanotwinned NiCoCr Alloys

MODELLING THE YIELD STRENGTH AND DUCTILITY IN COMPOSITE NANOTWINNED COPPER

A molecular dynamics investigation into deformation mechanism of nanotwinned Cu/high entropy alloy FeCoCrNi nanolaminates

Dislocation Density-Based Model for Flow Behavior of a Near-α Titanium Alloy Considering Effects of Initial Lamellar Thickness

Ultra-high strength and plasticity mediated by partial dislocations and defect networks: Part II: Layer thickness effect

Molecular dynamics studies of the effect of intermediate Fe layer thickness on the enhanced strength and ductility of Cu/Fe/Ni multilayer

Uniaxial Tension Deformation Study of Copper/nickel Laminated Composites: Effects of Lamella Number and Interlamellar Spacing

Interface-affected mechanical properties and strengthening mechanisms in heterogeneous high entropy alloy nanolaminates

Modeling the Effect of Diffusion Layer and Interface on the Flow Stress for a Ni/Al Laminate Prepared by Vacuum Hot Pressing

Effect of thickness on mechanical properties of hollow copper nano-cylinder by molecular dynamics

Atomistic simulations of mechanical response of a heterogeneous fcc/bcc nanolayered composite

Enhancing co-deformation ability of nanograined Ni-W layers in the Ni/Ni-W laminated composites

Mechanical properties and strengthening mechanism of Ni/Al nanolaminates: role of dislocation strengthening and constraint in soft layers

Size-dependent microstructural evolution and mechanical properties of crystalline/amorphous high-entropy alloy nanostructured multilayers: Cu/FeCoCrNiBSi vs Ni/FeCoCrNiBSi

Influence of interface on deformation compatibility of a heterogeneous Cu/Al nanoscale multilayer

Effect of Al2Cu constituent layer thickness discrepancy on the tensile mechanical behavior of Cu/Al2Cu/Al layered composites: A molecular dynamics simulation

Influence of twinning thickness on the mechanical properties of crystalline-amorphous dual-phase CoCrFeNiMn high entropy alloy