Abstract:In the serviced components of a 7075 aluminum alloy, the propagation of fatigue crack can be retarded because of the overload effect; however, the corresponding retardation mechanisms are complex. To provide further insights into the retardation mechanisms of 7075 aluminum alloys, this study addresses the crack tip damage response of a cracked 7075 aluminum alloy under an overload effect. Based on the dual-scale modeling approach and the damage-coupled crystal plasticity model, the effect of the microstructure of a 7075 aluminum alloy on the damage behavior ahead of the crack tip under an overload was studied. The factors affecting fatigue damage accumulation ahead of the crack tip, such as dislocation density, the variation in the activities of slip systems, and the orientation effect of the nearest neighbor grains, are described. The results show that for the 7075 aluminum alloy, the compressive residual stress induced by the overload effect not only decreases the number of activated slip systems, but also lowers the rate of increase in dislocation density. This causes a decrease in fatigue damage accumulation during deformation. Moreover, the overload effect decreases the slip system activity as well as the resultant plastic slip; however, the decrease in plastic slip varies with the grain orientation, indicating that the overload effect depends on the grain orientation. It can also be found that both the damage strain energy release rate and lattice strain are influenced by the orientation of the nearest neighbor grains, which can eventually affect the overload effect. These findings contribute to understanding the retardation mechanisms from a microscopic perspective and provide guidance on improving the material design of a 7075 aluminum alloy to some extent.

Effect of single tensile overload on fatigue crack growth behavior of CP-Ti at negative load ratio

Effects of Tensile/compressive Overloads on Fatigue Crack Growth Behavior of an Extra-Low-interstitial Titanium Alloy

Fatigue crack growth under mixed mode I-II loading with a single tensile overload at negative load ratios

Instrumented indentation measurements of residual stresses around a crack tip under single tensile overloads

DIC-based Studies of the Overloading Effects on the Fatigue Crack Propagation Behavior of Ti-6Al-4V ELI Alloy

Numerical investigation of mechanical behavior of crack tip under mode I and mixed-mode I-II fatigue loading at negative load ratios

Experimental and numerical investigation on fatigue crack growth behavior of commercial pure titanium under I-II mixed mode loading at negative load ratios

Overload-induced anisotropy of fatigue crack growth in laser deposited Ti-6Al-4V alloy

Effect of overload occurence frequency on fatigue crack growth rate of steel A537

STUDY OF FATIGUE CRACK GROWTH RETARDATION, CRACK TIP DEFORMATION AND CRACK CLOSURE UNDER SINGLE OVERLOAD APPLICATION FOR A537 STEEL

A Study on Fatigue Crack Closure Associated with the Growth of Long Crack in a New Titanium Alloy

Retardation mechanisms and modeling of fatigue crack growth of a high-strength steel after single overload

Effect of stress ratio and overload on mixed-mode crack propagation behaviour of EA4T steel

Effect of single overload on fatigue crack propagation rate for AISI 321 stainless steel under constant ΔK control

Experimental investigation of overload effects on fatigue crack growth behaviour of 7050‐T7451 aluminium alloy

Fatigue Crack Growth Behavior of CP-Ti Cruciform Specimens with Mixed Mode I-II Crack under Biaxial Loading

The Overload Effect on the Crack Tip Damage Mechanism in a 7075 Aluminum Alloy

In‐plane biaxial ratcheting effect and low‐cycle fatigue behavior of CP‐Ti based on DIC method

Near-tip Strain Evolution and Crack Closure of Growing Fatigue Crack under a Single Tensile Overload

Verification of stress transfer mechanism in fatigue crack growth under overload

Effect of stress ratio on high cycle fatigue behavior of TNM‐TiAl alloy