Abstract:Downhole drilling operations expose tungsten carbide based sintered (WC–5.7Co–0.3Cr) and sprayed (WC–10Co–4Cr) hardmetals to abrasives of different sizes. Although the effect of abradant size on the abrasive wear of metals has been widely studied, the effect of particle size on the abrasive wear of sintered and sprayed tungsten carbide-based hardmetals has not been examined previously. The abrasion of hardmetal composite surfaces is complex due to the presence of hard and soft phases which respond differently during abrasive wear, where an increase in abrasive size leads to a change in the wear mechanism which significantly affects the overall wear rates. Three different abrasive sizes, 4.5μm, 17.5μm and 180μm, were used in a modified ASTM G65 rubber wheel abrasion test to examine the effects of abrasive size on wear in a sintered WC and a D-gun sprayed WC-based coating. Uniquely, influential parameters affecting the wear mechanisms have been examined and identified with the fundamental material properties of both abrasives and the multi-phase materials. As a unique way of mapping abrasion performance, a parameter previously developed for the micro-abrasion tester, ‘severity of contact’, has been reworked and plotted against a ‘brittleness factor’ parameter developed in this work. Plotting these parameters can explain the sharp rise in wear rates associated with the transition from ductile, plastic deformation dominated material removal to a more fracture-related material removal as the size of abrasives increases. This work has developed new insights into how hardmetal composites respond to change in abrasive size and provides a basis for controlling the abrasive particle size.

Wear mechanisms in polymer matrix composites abraded by bulk solids

Abrasive wear of graphite fiber-reinforced polymer composite materials

Influence of fillers and fibre reinforcement on abrasive wear resistance of some polymeric composites

Evaluation of polymer composites for sliding and abrasive wear applications

Abrasive wear behavior of particle reinforced ultrahigh molecular weight polyethylene composites

Evaluation of Engineering Polymeric Composites for Abrasive Wear Performance

An investigation of the wear of polymeric materials

Experimental investigation of wear of multiwalled carbon nanotube particles-filled poly-ether-ether-ketone matrix composites under dry sliding

Characteristics and mechanism of abrasive wear of particle reinforced UHMWPE matrix composite

Wear and Frictional Performance of Epoxy Composites Reinforced with Natural Waste Fibers and Fillers for Engineering Applications

Effect of abrasive particle size and the influence of microstructure on the wear mechanisms in wear-resistant materials

Friction and wear behavior of polyetherimide composites in various wear modes

Effect of reinforcement on wear debris of carbon nanofiber/high density polyethylene composites: Morphological study and quantitative analysis

Abrasive wear of some commercial polymers

Surface topography modification, Film transfer and Wear mechanism for fibre reinforced polymer composites—An Overview

Abrasive Sensitivity of Engineering Polymers and a Bio-Composite under Different Abrasive Conditions

Abrasive Wear Mechanism of Microwave-Assisted Compression Molded Kenaf/HDPE Composite

Wear Failures of Plastics

Investigation of Three-body Abrasive Wear Mechanism of Polymer Urethanes Composites Reinforced by High Strength Pearlitic Steel Wire

Effect of Wear Conditions, Parameters and Sliding Motions on Tribological Characteristics of Basalt and Glass Fibre Reinforced Epoxy Composites

Characteristics and mechanism of abrasive wear for thermoplastic polymers