Abstract:The fundamental differences between friction and wear under impact and friction and wear under sliding are the pressure (i.e. the load responsible for friction) and the friction coefficient. The dynamic equivalents of both factors are determined for impact effects by specific parameters; these parameters are the particle velocity ν0 and the angle α0 of attack. The pressure is given by π = ρν02sin2α0 and the friction coefficient by f = ν0 cosα0 − νf cosαfν0 sinα0 + νf sinαfIn the range of small and medium values of α0 the impact friction coefficient for elastomers decreases with an increase in the angle of attack and increases with increases in the angle of attack for plastics. For large values of α0 the friction coefficient of all materials decreases and approaches zero at normal impact.The friction coefficient under impact is of fundamental importance to wear by a flow of particles because it defines the fatigue strength of the body being worn. To increase wear resistance under impact this friction coefficient should be lowered; this is similar to the case of sliding friction and wear.For microcutting by a colliding particle, in contrast with sliding, it is advantageous to have an increased coefficient of friction under impact.When the similarity between the pressures p and Π is taken into account, the expressions for sliding wear and impact wear are analogous. Because the initial process of failure is the same in both cases, the relationship between the wear resistance and the properties of the material being worn (strength, deformability, endurance and friction coefficient) is the same in both cases. In the microcutting of plastics an increased hardness is important. In the microcutting of vulcanizates by flying particles an increased modulus of elasticity is important.

Characteristics and mechanism of abrasive wear for thermoplastic polymers

An investigation of the wear of polymeric materials

The Mechanism of Tribological Wear of Thermoplastic Materials

Characteristics of fretting wear resistance for unfilled engineering thermoplastics

Wear Failures of Plastics

Influence of adhesive and abrasive mechanisms on the tribological behaviour of thermoplastic polymers

Abrasive wear of some commercial polymers

Advance in Wear-Resisting Thermosetting Polymers and Composites

Abrasive wear of graphite fiber-reinforced polymer composite materials

Characteristics of impact friction and wear of polymeric materials

Abrasive Sensitivity of Engineering Polymers and a Bio-Composite under Different Abrasive Conditions

Investigation of the Friction and Wear Properties of Modified PA66 Composites

An Analytical Model of Mechanistic Wear of Polymers

Influence of Crystallinity on Wear Behavior of Ultrahigh Molecular Weight Polyethylene and the Wear Mechanism

Abrasive wear behaviour of polymeric materials

Thermal analysis of the wear debris of polyetheretherketone

Abrasive wear behavior of particle reinforced ultrahigh molecular weight polyethylene composites

Effect of crystalline form on the tribological properties of PA46/HDPE polyblends

Thermal and Mechanical Mechanisms of Polymer Wear at the Nanoscale

Friction and Wear of Polymer and Polymer Composites

Development of Research on Friction and Wear of High Performance and High Temperature Polymer Composites