Abstract:The effects of temperature on the tribological and dynamic mechanical properties (DMP) of aromatic liquid-crystal poly(ester-co-amide) were investigated. Specimens for the DMA test and friction and wear test were prepared by compression molding at elevated temperature. The dynamic mechanical properties of the resulting compression-molded liquid crystal polymer (LCP) specimens were evaluated on a Perkin-Elmer DMA instrument, in a three-point bending mode, at a heating rate of 10°C/min and frequency of 1Hz from room temperature to 250°C. The friction and wear behavior of the compression-molded LCP specimens sliding against SA52100 steel in a ball-on-disk configuration was evaluated on a high-temperature friction and wear tester from 25 to 300°C. The worn surface morphologies of the compression-molded LCP specimens were observed on a scanning electron microscope. It was found that the tribological and dynamic mechanical properties of the LCP strongly depended on the test temperature. Namely, the friction coefficients decreased significantly and the wear rate increased considerably with increasing temperature. This was attributed to the enhanced softening and plastic deformation of the LCP at elevated temperature. The LCP experienced severe plastic deformation, flowing and local melting owing to the destruction of the stiff backbones of the polymeric molecules at excessively high temperature, thus the largest wear rate of the tested LCP was generated at 300°C. Such a trend in the friction and wear behavior of the compression-molded LCP with temperature conformed well to the corresponding worn surface morphologies. Namely, the LCP worn surface was characterized by mild plastic deformation and micro-cracking as the LCP disk slid against the steel ball at 50°C, whilst at 100°C, the plastic deformation and adhesion became severe and the micro-cracking disappeared owing to the plastic flow. The plastic deformation and adhesion became increasingly more severe with further increase of the test temperature up to 150, 200, and 250°C, owing to the increased plastic flow and local softening and melting of the LCP. Moreover, the storage modulus of the compression-molded LCP greatly decreased with increasing temperature, as did the loss modulus, while the complex modulus and tan δ increased with increasing temperature, which agreed well with the corresponding trend of the tribological behavior with temperature. It was confirmed that the dynamic mechanical properties of the polymer were an important factor of the high temperature tribological behavior.

Thermal and Mechanical Mechanisms of Polymer Wear at the Nanoscale

Effect of Temperature on the Tribological and Dynamic Mechanical Properties of Liquid Crystalline Polymer

The Mechanism of Tribological Wear of Thermoplastic Materials

Micromechanism of wear at polymer-metal sliding interface

Research on the Friction and Wear Mechanism of a Polymer Interface at Low Temperature Based on Molecular Dynamics Simulation

An Analytical Model of Mechanistic Wear of Polymers

Friction and Wear of Polymer and Polymer Composites

Wear Failures of Plastics

An investigation of the wear of polymeric materials

Nanoscale wear as a stress-assisted chemical reaction

Characteristics and mechanism of abrasive wear for thermoplastic polymers

Advance in Wear-Resisting Thermosetting Polymers and Composites

Nanoscale Wear Triggered by Stress-Driven Electron Transfer

The effects of initial and in-situ generated roughness on polymer wear: Voluntary vs. involuntary

Wear transitions and tribochemical reactions in ceramics

Study on the Tribological Properties of Polymer Interface and the Mapping Mechanism of Friction Noise in a Wide Temperature Range

Adhesive wear mechanisms in the presence of weak interfaces: Insights from an amorphous model system

Effect of wear particles and roughness on nanoscale friction

Wear and aging behavior of vulcanized natural rubber nanocomposites under high-speed and high-load sliding wear conditions

Fundamental wear mechanism of metals

Mechanistic Studies in Friction and Wear of Bulk Materials