Abstract:Effects of various counterface roughness components (i.e., magnitude, density, direction) on polymer wear and transfer film are strongly coupled and difficult to isolate and test. Previous works found counterface roughness grooves and ridges perpendicular to the direction of sliding were generally beneficial to debris retention and tribofilm formation, but the effect was competing with a decrease in debris retention caused by in-situ generated furrows parallel to the direction of sliding. To further study the effect of roughness directionality on polymer wear, a model polymer solid lubricant (5 wt% Al2O3-PTFE) was slid against counterfaces with laser-textured grooves parallel to the direction of reciprocated sliding and a 2 × 3 variable matrix of groove depth and density. The results found: (1) all textures yielded higher polymer wear than the untextured surface did, (2) counterface with the deepest, densest grooves had the highest polymer wear rate and transient wear volume (wear volume during run-in sliding), (3) shallow groove textures generally produced less wear of the counterface and polymer, stronger tribofilm IR signature and more continuous and complete tribofilms than deep groove textures did. A new roughness parameter (IRa) was defined as a single, unified and comprehensive metric for counterface roughness directionality. By comparing with a previous study, the results found a general correlation between IRa and polymer transient wear volume and suggested strong beneficial effects of perpendicular grooves on debris retention and parallel grooves on debris ejection. A simple framework was postulated to illustrate the interrelations between texture parameters, roughness directionality and debris mobility. It was further supported by analyzing results of a closely relevant work. Although being strongly limited to the model polymer solid lubricant, this study provides perhaps some useful tools for advancing our understanding of the complex relations between roughness directionality, debris mobility (e.g., ejection, retention) and wear of polymer solid lubricant.

The effects of initial and in-situ generated roughness on polymer wear: Voluntary vs. involuntary

The unrecognized importance of roughness directionality to polymer wear

The limit of adhesive debris retention: A case study using ultra-low wear Alumina–PTFE

Effect of Contact Forms on the Wear of Hard Silicon Surfaces by Soft Polymers

An investigation of the wear of polymeric materials

A Study of the Effect of Roughness on the Three-Body Wear Mechanism from a Microscopic Point of View: Asperity Peak Removal

An Analytical Model of Mechanistic Wear of Polymers

Direct Measurement of Plowing Friction and Wear of a Polymer Thin Film Using the Atomic Force Microscope

Roughness evolution induced by third-body wear

Scratching of polymers—Modeling abrasive wear

TRANSFER LAYER DYNAMICITY IN ROLL-SLIP OF POLYMER METAL PAIRS

Abrasive wear of PEEK and ATSP-based polymer composite coatings under lunar regolith conditions

Thermal and Mechanical Mechanisms of Polymer Wear at the Nanoscale

Friction and wear characteristics modification via laser surface textured grooves

Wear and surface degradation of commercial ZTA femoral heads under boundary lubrication conditions

The influence of polymer composition on the wear of the metal surface during fretting of steel on polymer

Effect Of Surface Roughness And Wear In Lubricated Of Self-Mated Alumina On Friction Reciprocating Sliding Contact

Fundamental aspects and recent progress on wear/scratch damage in polymer nanocomposites

Coupled effect of filler and countersurface roughness on the tribological performance of the PEEK-PTFE-steel hybrid wear system

Effect and performance analysis of different surface treatments on polymer-metal friction pairs

Quantitative Study of Surface Roughness Evolution During Low-Cycle Fatigue of 316L Stainless Steel Using Scanning Whitelight Interferometric (SWLI) Microscopy