Abstract:The AC losses, the current density and the magnetic field are important variables to design devices made of High Temperature Superconductors (HTS). These variables are often numerically computed using a transient finite element analysis even though the interest may lay in the steady-state regime of the device. The need for solving time-dependent variables has led to improve the computation time with efficient finite element models (FEM) relying on different formulations. These transient FEM are computationally slow and demanding in terms of resources. In the present work, an alternative path is taken with the development of a frequency-domain FEM using a phasor representation to alleviate the computation burden. This model does not have the versatility of the transient models. However, it can generate the initial steady-state conditions for a subsequent transient analysis. It is perfectly adapted to study the steady-state regime of HTS devices operated in AC conditions. In this phasor modelling approach, the Root Mean Square (RMS) resistivity of the superconductor is introduced. It is subsequently approximated by an exponential function introducing a factor to ease its implementation in the commercial software COMSOL Multiphysics with the most recent and fastest formulations T-A and J-A. The case studies encompass single BSCCO and REBCO tapes as well as a CORC cable or specifically, in the present work, a CORT (Conductor on Round Tube). The results of the time- and frequency-domain FEM simulations are compared against experimental data. The comparison of the models' results is carried out comparing the current density distributions as well as the AC losses. The comparison against experimental data is only conducted on the AC losses. In the present case, it is used to quantify thoroughly the accuracy of the numerical results compared to the measurements. A reasonable agreement between those results and the experimental data was found.

High Tc superconductor voltage-current simulator and the pulse method of measuring critical current

MEASUREMENT OF CRITICAL CURRENT FOR HIGH TEMPERATURE SUPERCONDUCTORS

Contactless Measurement of Critical Current of High Temperature Superconductor Tape by Magnetic Circuit.

A pulsed current set-up for use in magnetic fields above 30 T; application to high-temperature superconductors

Fast evaluation of the critical current of high-temperature superconducting coils based on the integral method

Continuous Critical Current Measurement of High-Temperature Superconductor Tapes with Magnetic Substrates Using Magnetic-Circuit Method.

Critical-Current and Its Determination on Tlsr2ca2ba2cu3oy by Ac Susceptibility Measurement

A Method for Continuous Measurement of Critical Current of HTS Tapes Using Magnetic Circuits

Fundamental nature of the self-field critical current in superconductors

Numerical Simulation and Analysis of A Saturated-Core-Type Superconducting Fault Current Limiter

Simulation Method for Current-Limiting Effect of Saturated-Core Superconducting Fault Current Limiter

A frequency-domain finite element model for simulating high-temperature superconductors using the J-A and T-A formulations

Influence of Critical Current Distribution on Operation, Quench Detection and Protection of HTS Pancake Coils

Simplified Two-Fluid Current–voltage Relation for Superconductor Transition-Edge Sensors

Over-Current Simulation Test for High Temperature Superconducting Generator

AC Analysis of a High Temperature Superconductor Coil with Short Circuits

The Critical Current of Disordered Superconductors near T=0

Visualization of Thermal Processes in Superconducting Composites under Critical Current Loads

Standard measurement method for normal state resistance and critical current of resistively shunted Josephson junctions

Critical-current density from magnetization loops of finite high-Tc superconductors

Design for In-Field Critical Current Measurement System With 102 Mm 15 T Background Magnet