Abstract:In this paper, we investigate the use of a MiniPIX (Timepix3) hybrid pixel detector as a single layer Compton camera for low-energy (< 200 keV) photons for Nuclear Medicine imaging applications. Literature to date has focused on using Compton camera imaging for high energy photons emitted from non-clinically relevant radionuclides. This paper aims to investigate Compton imaging for nuclear medicine specific radionuclides such as Tc 99m (140 keV). For this, a Timepix3 chip with a 1 mm CdTe sensor has been fully characterised in terms of efficiency, energy and timing resolution using a range of point sources, and a detailed model of the detector developed using the EGSnrc Monte Carlo toolkit. Knowledge of the specific interaction points within the detector in the simulation allowed a prediction to be made of the performance of the detector as a Compton camera. Comparison with experimental measurements showed good agreement with simulations, providing validation of the methods employed for image reconstruction. Simple Back Projection (SBP), Filtered Back Projection (FBP) and List Mode-Maximum Likelihood Expectation Maximisation (LM-MLEM) techniques were used for image reconstruction. For all experimental acquisitions, measured Full Width Half Maximum (FWHM) values were within 6% of the modelled values, with Doppler broadening identified as the main limiting factor of the spatial resolution of the system. LM-MLEM consistently returned the highest spatial resolution images, with a 7.3 ± 0.5 mm FWHM achieved for 99m Tc point sources, consistent with current clinical gamma cameras. Our results demonstrate the potential of the Timepix3 as a single layer CdTe Compton camera for clinical applications using low energy gamma emitters. The developed MC model will provide a means of investigating larger area, single layer CdTe Compton cameras for nuclear medicine imaging.

A simulator for Timepix-like pixel front-ends

A Simulation System and Its Applications for Signal Readout of CMOS Pixel Sensors in High Energy Physics Experiments

Timepix3: single-pixel multi-hit energy-measurement behavior

Combining TCAD and Monte Carlo Methods to Simulate CMOS Pixel Sensors with a Small Collection Electrode using the Allpix Squared Framework

Characterisation of a customised 4-chip Timepix3 module for charged-particle tracking

Time calibration studies for the Timepix3 hybrid pixel detector in electron microscopy

Probability distribution maps of deposited energy with sub-pixel resolution for Timepix3 detectors

An Energy and Time Measurement ASIC for Large Pixel Semiconductor Detectors for Spectroscopic and Imaging Applications

Demonstrating the Q-Pix front-end using discrete OpAmp and CMOS transistors

Development of a single-photon imaging detector with pixelated anode and integrated digital read-out

A Full Functional Monolithic Active Pixel Sensor Prototype for the CEPC Vertex Detector

Front-end Electronics for Timing with pico-seconds precision using 3D Trench Silicon Sensors

28 nm front-end channels for the readout of pixel sensors in future high-rate applications

Timing performances of front-end electronics with 3D-trench silicon sensors

Silicon Carbide Timepix3 detector for quantum-imaging detection and spectral tracking of charged particles in wide range of energy and field-of-view

Test-beam Performance Results of the FASTPIX Sub-Nanosecond CMOS Pixel Sensor Demonstrator

Performance of a GridPix detector based on the Timepix3 chip

AstroPix4 — a novel HV-CMOS sensor developed for space based experiments

Transient Signal Simulation in Pixel Semiconductor Detectors under Pulsed High-Flux Radiation

An experimental and computational evaluation of a novel Timepix3 detector for Compton imaging in nuclear medicine

Casca: A Readout Asic For A Tpc Based X-Ray Polarimeter