Effect of Interface Property on the Agglomeration Characteristic of Inclusions in High Al Steel with Different Al Contents

Xu Zang,Chengjun Liu,Yeguang Wang,Zhigang Liang

DOI: https://doi.org/10.1002/srin.202400248

IF: 2.1258

2024-07-25

steel research international

Abstract:The present study innovatively observes the agglomeration behavior of inclusions in the high Al steel with different Al contents by confocal laser scanning microscopy and calculates the agglomeration force of inclusions with different Al contents. Then the present study theoretically calculates the effect of Al content on the agglomeration force of inclusions and further validates the experimental results. Herein, a 3D stability diagram is established in the AlON system. Based on that, four sets of experiments with different Al contents are designed to prepare different inclusions. Subsequently, the agglomeration behavior of inclusion is observed in situ by using confocal laser scanning microscopy (CLSM) combined with an infrared image furnace. The sample with inclusions is heated to melt and the agglomeration behavior of inclusion is recorded by the CRT monitor of CLSM. The calculated agglomeration force of inclusion shows that when the Al content increases from 0.5 to 3 pct, the agglomeration force of Al2O3 inclusions decreases from 7.2 × 10−16 ≈ 6.0 × 10−14 N to 1.2 × 10−16 ≈ 3.2 × 10−15 N. As the Al content increases from 6.5 to 10 pct, the agglomeration force of AlN inclusions increases from 2.2 × 10−17 ≈ 1.1 × 10−15 N to 1.7 × 10−16 ≈ 7.9 × 10−15 N. The theoretical calculation also shows that the agglomeration force of Al2O3 inclusions decreases and that of AlN inclusions increases with the increasing Al content. When the Al content is >4.7 pct, the agglomeration force of AlN inclusions is larger than that of Al2O3 inclusions.

metallurgy & metallurgical engineering