Abstract:Glacial geology, marine environment, and arid climate govern the composition of clay tills. The main purpose of this work is to develop a clear understanding of the engineering behavior of compacted clay till under soil suction and applied stress. The results indicate moderate water adsorption due to the presence of clay minerals (26% corrensite, 10% illite, and 8% kaolinite) with Ca2+ as the dominant cation and a flocculated fabric in a slightly basic (pH = 7.5) pore water. The water retention curve comprised four transition points that are associated with capillary water drainage from large pores (air entry value of 2 kPa and residual suction value of 20 kPa) and small pores (air entry value of 700 kPa and residual suction value of 5 × 104 kPa). Beyond the last value, vapor flow is dominant and removes the adsorbed water by evaporation. The ratio of soil volume change to water volume change best described the s-shaped shrinkage path that also comprised four stages, namely: from most large pores with low volume change; from remaining large and most small pores along with almost equal volume change; from some small pores with low volume change; and from the rest of the small pores with no volume change. Likewise, the s-shaped swelling potential curve comprised three stages and correlated well with bimodal hydraulic conductivity curve, that is, slow initial swelling (unsaturated hydraulic conductivity around 10−14 m/s) due to expansion of peripheral clay in lumps; high primary swelling (unsaturated hydraulic conductivity of up to 10−11 m/s) due to thickened double layer of most colloids; and slow secondary swelling (albeit unsaturated hydraulic conductivity around 10−10 m/s) due to expansion of remaining particles. Soil compression (compression index of 0.164) was due to a gradual reduction in number of large pores, whereas rebound (swelling index of 0.047) was due to water adsorption on clay with part of the deformations recovered. Finally, the consolidation rate was related to saturated hydraulic conductivity, which varied by three orders of magnitude.

Hydrothermal properties of compacted natural and lime-stabilized tufa: capillary absorption and thermal properties

Long-term Thermal Performance of Oil Well Cement Modified by Silica Flour with Different Particle Sizes in HTHP Environment

Effects of water and temperature variations on deformation of limestone aggregates, cement paste, mortar and High Performance Concrete (HPC)

On the Structural, Thermal, Electrical and Mechanical Properties of Compacted Bentonite Material

Fabric Alteration of a Compacted Lime-Treated Expansive Soil upon Drying and Wetting

Experimental study of relative humidity absorbed through capillarity of building material under isothermal conditions: Clay-Kaolin reinforced with Alfa fibers

Changes in Thermal Conductivity, Suction and Microstructure of a Compacted Lime-Treated Silty Soil During Curing

One-dimensional compression creep change under temperature and suction effects

The effect of undrained heating on a fluid-saturated hardened cement paste

Effects of Freeze–thaw Cycles and Porosity/cement index on Durability, Strength and Capillary Rise of a Stabilized Silty Soil Under Optimal Compaction Conditions

Study on Compressive Strength and Thermal Properties of New Cementitious Thermal Storage Material

Pore fluid salinity effects on post-stabilization performance of cement-treated Marl

Experimental Investigation on the Effects of Mineral Water Composition on the Leaching of Cement-Based Materials

Geotechnical and thermal analysis and complex impedance spectroscopy characterization of pure Moroccan bentonite material for civil engineering applications

Carbonation and Related Behaviors of Hardened Cement Pastes under Different Hydration Degrees

Effect of Curing Temperature on Mechanical Strength and Thermal Properties of Hydraulic Limestone Powder Concrete

Investigation on Behavior of Thermal Expansion of Hydraulic Cement Paste

Associated Evolutionary Mechanism of Hydration-Pore for Montmorillonite Modified by Ionic Soil Stabilizer

Experimental Study of Thermal Conductivity in Soil Stabilization for Sustainable Construction Applications

Swell-compressibility characteristics of lime-blended and cement-blended expansive clays – A comparative study

Effect of Composition on Engineering Behavior of Clay Tills