Abstract:In this research, a high-efficiency design method of the capacitive MEMS accelerometer is proposed. As the MEMS accelerometer has high precision and a compact structure, much research has been carried out, which mainly focused on the structural design and materials selection. To overcome the inconvenience and inaccuracy of the traditional design method, an orthogonal design and the particle swarm optimization (PSO) algorithm are introduced to improve the design efficiency. The whole process includes a finite element method (FEM) simulation, high-efficiency design, and verification. Through the theoretical analysis, the working mechanism of capacitive MEMS accelerometer is clear. Based on the comparison among the sweep calculation results of these parameters in the FEM software, four representative structural parameters are selected for further study, and they are le, nf, lf and wPM, respectively. le and lf are the length of the sensing electrode and fixed electrode on the right. nf is the number of electrode pairs, and wPM is the width of the mass block. Then, in order to reduce computation, an orthogonal design is adopted and finally, 81 experimental groups are produced. Sensitivity SV and mass Ma are defined as evaluation parameters, and structural parameters of experimental groups are imported into the FEM software to obtain the corresponding calculation results. These simulation data are imported into neural networks with the PSO algorithm. For a comprehensively accurate examination, three cases are used to verify our design method, and every case endows the performance parameters with different weights and expected values. The corresponding structural parameters of each case are given out after 24 iterations. Finally, the maximum calculation errors of SV and Ma are 1.2941% and 0.1335%, respectively, proving the feasibility of the high-efficiency design method.

Design and implementation for the PWM closed-loop feedback interface circuit of a sandwich capacitive accelerometer based on ARM

Design Of The Closed-Loop Capacitive Micro-Accelerometer Based On Pspice

Design of Force-Balance Capacitive Accelerometer

A Stiffness-Tunable MEMS Accelerometer

Comprehensive Optimization of Pid-Type Closed-Loop Mems Accelerometer System

A Low-Power Digital Processing Circuit for Capacitive Accelerometer

Fuzzy Sliding-Mode Control of the Electrostatically Tuned Quasi-Zero Stiffness MEMS Accelerometer.

System-level Simulation and Implementation for a High Q Capacitive Accelerometer with PD Feedback Compensation

CMOS interface circuit for closed-loop accelerometer

Research on High-Resolution Miniaturized MEMS Accelerometer Interface ASIC

A Pseudo-Differential Capacitive MEMS Accelerometer Analog Front-End Design

The High-Efficiency Design Method for Capacitive MEMS Accelerometer

Modeling and Analysis of a Closed-Loop System for High-Q MEMS Accelerometer Sensor

A Low-Noise Closed-Loop Interface For High-G Capacitive Micro-Accelerometer

A High-Voltage Closed-Loop SC Interface for a ± 50 G Capacitive Micro-Accelerometer with 112.4 Db Dynamic Range

Stabilization Control of a MEMS Accelerometer With Tuned Quasi-Zero Stiffness

Time Divided Architecture for Closed Loop MEMS Capacitive Accelerometer

An Offset-Compensated Switched-Capacitor Interface Circuit for Closed-Loop Mems Capacitive Accelerometer

Programmable Readout Circuit For Capacitive Accelerometer

Design and Fabrication of a Micro-Electromechanical System Sandwich Capacitive Accelerometer

Interface Circuit for Capacitive Microaccelerometer