Abstract:Following the large‐scale integration of distributed power sources into distribution networks, fault currents undergo noticeable changes, which impacts the accuracy of conventional single‐phase ground fault algorithms. To tackle these issues, this work initially proposes an active distribution network ground fault protection algorithm based on the direction of extreme energy. Then, by establishing the electrical system structure and model of distribution network ground faults in the presence of distributed power sources, theoretical derivations and computations of transient zero‐sequence current frequency variations during fault instances are carried out. The characteristics of zero‐sequence current directions under distributed power sources integration are analysed, facilitating the design of a local ground fault determination algorithm grounded in the principle of energy extremum direction. This includes outlining fault determination and isolation procedures for ground fault monitoring equipment. Finally, through simulation testing, it is proven that the algorithm can reliably detect ground faults under both neutral point grounding configurations involving an arc suppression coil and ungrounded systems, across a range of transition resistances, varying numbers and capacities of distributed power sources connected, and differing grounding switch operation angles. After large‐scale distributed power sources are connected to the distribution network, the fault current undergoes noticeable changes, affecting the accuracy of traditional single‐phase grounding fault algorithms. Therefore, the objective of this paper is to address the impact of distributed power integration on the grounding algorithms of distribution networks. The main contribution is: by establishing an electrical system structure and model for distribution network grounding faults that include distributed generation (DG), theoretically deriving and calculating the transient zero‐sequence current frequency changes at the moment of fault, analysing the directional characteristics of zero‐sequence currents under DG connection conditions, designing a local grounding fault judgment algorithm based on energy extremum direction, and providing a fault judgment and isolation process for grounding fault monitoring devices. The results show: through simulation and experimentation, the algorithm was tested, and the method can reliably judge grounding faults under various transition resistances, different numbers and capacities of connected distributed power sources, and different grounding switch‐on angles. The applicability of the algorithm covers both methods of neutral grounding through an arc suppression coil and ungrounded neutrals, adapting to scenarios with or without DG connections.

Ground-Fault Recognition in Low-Voltage Ships Based on Variation Analysis of Phase-to-Ground Voltage and Neutral-Point Voltage

Single-phase-to-ground Fault Detection with Distributed Parameters Analysis in Non-Direct Grounded Systems

Research on Grounding Fault Protection for Shipboard Medium Voltage DC System

Mechanism Research of High Resistance Grounding for Shipboard Medium Voltage Power Grid

Mechanism study of resonant neutral grounding scheme for shipboard medium voltage power grid

Fault Location Analysis of Ungrounded Distribution System Based on Residual Voltage Distribution

A New Approach for Single-Phase-to-Ground Fault Detection in Mid-Voltage Systems Using Low-Voltage Sensors

Performance of Shipboard Medium-Voltage DC System of Various Grounding Modes under Monopole Ground Fault

Grounding Failure Detection Based on Wavelets Method in Resonant Grounded Power Distribution System

Fault Analysis of Neutral Point Ungrounded System Single-phase not Fully Grounded

An Overview of Grounding Design and Grounding Fault Detection and Location Methods for a Multiphase Rectifier Generator Power Supply System

High Voltage Shore Connection Systems: Grounding Resistance Selection and Short Circuit Currents Evaluation

A Novel Fault Detection and Location Approach for DC Zonal Shipboard Microgrid Based on High-Frequency Impedance Estimation With IEC 61850 Communication Protocol

Assessing High-Voltage Shore Connection Safety: An In-Depth Study of Grounding Practices in Shore Power Systems

A new principle to detect the grounded line in a neutral point indirectly grounded power system based on the energy function

Traveling Wave Based Single-Phase-to-ground Protection Method for Power Distribution System

A novel online monitoring method of ground fault in tree form distribution networks based on power line carrier devices

An Earth Fault Diagnosis Method Based On Online Dynamically Calculated Thresholds for Resonant Ground Systems

Detection of Single-Phase to Ground Faults in Low-Resistance Grounded MV Systems

Ground fault protection algorithm of active distribution network based on energy extremum direction

A Single-Phase to Ground Fault Location Method Based on Last-Squares Parameter Estimation in Arc-Suppression-Coil Grounding System