Abstract:Abstract This paper presents 3D Fabry–Pérot (FP) cavities fabricated directly onto cleaved ends of low-loss optical fibers by a two-photon polymerization (2PP) process. This fabrication technique is quick, simple, and inexpensive compared to planar microfabrication processes, which enables rapid prototyping and the ability to adapt to new requirements. These devices also utilize true 3D design freedom, facilitating the realization of microscale optical elements with challenging geometries. Three different device types were fabricated and evaluated: an unreleased single-cavity device, a released dual-cavity device, and a released hemispherical mirror dual-cavity device. Each iteration improved the quality of the FP cavity’s reflection spectrum. The unreleased device demonstrated an extinction ratio around 1.90, the released device achieved 61, and the hemispherical device achieved 253, providing a strong signal to observe changes in the free spectral range of the device’s reflection response. The reflectance of the photopolymer was also estimated to be between 0.2 and 0.3 over the spectrum of interest. The dual-cavity devices include both an open cavity, which can interact with an interstitial medium, and a second solid cavity, which provides a static reference reflection. The hemispherical dual-cavity device further improves the quality of the reflection signal with a more consistent resonance, and reduced sensitivity to misalignment. These advanced features, which are very challenging to realize with traditional planar microfabrication techniques, are fabricated in a single patterning step. The usability of these FP cavities as thermal radiation sensors with excellent linear response and sensitivity over a broad range of temperature is reported. The 3D structuring capability the 2PP process has enabled the creation of a suspended FP heat sensor that exhibited linear response over the temperature range of 20 oC –120 oC; temperature sensitivity of ∼50 pm oC −1 at around 1550 nm wavelength; and sensitivity improvement of better than 9x of the solidly-mounted sensors.

Design and fabrication of fiber optic microlenses using an arc fusion splicing system

Splicing Optical Microfibers Via Polymer Nanowires

In Situ Fabrication of a Tunable Microlens.

Flexible fluidic lens with polymer membrane and multi-flow structure

Progress In Femtosecond Laser Fabrication Of Microlens Array With Spatial Light Modulators

Single- and multi-layer micro-scale diffractive lens fabrication for fiber imaging probes with versatile depth-of-field

Three-dimensional Fabry–Pérot cavities sculpted on fiber tips using a multiphoton polymerization process

Femtosecond laser 3D printed micro objective lens for ultrathin fiber endoscope

Fabrication of optical components with nm- to mm-scale critical features using three-dimensional direct laser writing

Fusion Splicing Soft Glass Microfibers for Photonic Devices

Fiber positioning in microlens-fiber coupled integral field unit

Laser Printed Fiber Microlens for Fiber-Diode Coupling by Direct Laser Writing

Photonic Crystal Fiber Metalens

Optical Nanofabrication of Concave Microlens Arrays

Control of Diameter and Numerical Aperture of Microlens by a Single Ultra-Short Laser Pulse

Tapered multi-core fiber for lensless endoscopes

Rapid Fabrication Of Continuous Surface Fresnel Microlens Array By Femtosecond Laser Focal Field Engineering

Arc Discharge Method to Fabricate Large Concave Structures for Open-Access Fiber Fabry-Pérot Cavities

Single-pulse Writing of a Concave Microlens Array.

3D Printing Mesoscale Optical Components with a Low-Cost Resin Printer Integrated with a Fiber-Optic Taper

Rapid fabrication of quasi-periodic aspherical concave microlens array with different focal lengths on fused silica by shaping picosecond laser-induced multi-step wet-etching for multi-layer optical imaging