Abstract:As an important electron transport layer (ETL) oxide, ZnO has been explored in colloidal quantum dot solar cells (CQDSCs), showing excellent power conversion efficiency (PCE), which however is significantly undermined when being subject to a low-temperature synthesis. To this end, in terms of utilizing 2-aminoethanol as a stabilizing ligand, highly stable ZnO nanoparticles were synthesized through a low-temperature (∼120 °C) reflux method and further utilized for the fabrication of the PbS CQDSCs, which were synthesized by oleic acid and 1-octadecence-assisted PbO decomposition strategy. The champion device with a configuration of glass/ITO/ZnO/PbS-EMII/PbS-EDT/Au achieves a high fill factor (FF) of 74.8% and appreciable PCE of 10.96%, slightly higher than that of the reference device with a ZnO ETL fabricated at 200 °C. This could be related to the high recombination resistance (Rrec of ∼465.8 ohms under light conditions) for the ZnO ETL-based PbS CQDSCs. What is more, these CQDSC devices demonstrate outstanding storage stability in an ambient environment, i.e., over 99% retention in PCE after 150 day storage. As highly efficient and stable CQDSCs are achieved, this work suggests a low-temperature strategy for ETL exploration. Our results may help to pave a feasible way for the development of low-temperature flexible PbS CQD solar cells.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsanm.1c01510.X-ray photoelectron spectroscopy (XPS) of ZnO NPs, current–voltage (I–V) measurements of ZnO NPs annealed at different temperatures in dark conditions, wide-scan convey spectra and O 1s XPS peaks of EMII-treated PbS CQDs, current density–voltage (J–V) curves and EQE spectra of ZnO-based PbS CQDSCs annealed at different temperatures, summarized solar cell parameters for ZnO films annealed at 120 and 200 °C, and comparison table of ZnO-based PbS CQDSC devices with other related literature.This article has not yet been cited by other publications.

Low-Temperature Synthesis of Stable CaZn$_2$P$_2$ Zintl Phosphide Thin Films as Candidate Top Absorbers

Low‐Temperature Synthesis of Stable CaZn2P2 Zintl Phosphide Thin Films as Candidate Top Absorbers

Low-temperature Preparation Achieving 10.95%-Efficiency of Hole-Free and Carbon-Based All-Inorganic CsPbI3 Perovskite Solar Cells

Discovery of the Zintl-phosphide BaCd$_{2}$P$_{2}$ as a long carrier lifetime and stable solar absorber

Investigation of a potential photovoltaic absorber based on first principles spectroscopic screening of chalcogenide perovskites: CaZrX3 (X = S, Se)

Towards low-temperature processing of efficient $γ$-CsPbI$_3$ perovskite solar cells

: a promising approach for next generation thin fi lm photovoltaics

Study of pnictides for photovoltaic applications

Structural, Electronic and Defect Properties of Cu<sub>2</sub>ZnSn(S,Se)<sub>4</sub> Alloys

Structural, Electronic and Defect Properties of Cu 2 ZnSn(S,Se) 4 Alloys

Targeting the imperfections at the ZnO/CsPbI2Br interface for low-temperature carbon-based perovskite solar cells

Low-Temperature-Processed ZnO Electron Transport Layers for PbS Colloidal Quantum Dot-Based Solar Cells

Efficient Stabilization and Passivation for Low-Temperature-Processed Γ-Cspbi3 Solar Cells

Efficient Stabilization and Passivation for Low-Temperature-Processed γ-CsPbI 3 Solar Cells

First-principles study of intrinsic and hydrogen point defects in the earth-abundant photovoltaic absorber Zn3P2

Highly efficient, ultrathin, Cd-free kesterite solar cells in superstrate configuration enabled by band level tuning via Ag incorporation

CZTS nanocrystals: a promising approach for next generation thin film photovoltaics

Low-Temperature Plasma-Enhanced Atomic Layer Deposition of ZnMgO for Efficient CZTS Solar Cells

$Mg_xZn_{1-x}O$ contact to $CuGa_3Se_5$ absorber for photovoltaic and photoelectrochemical devices

Low-cost kesterite (CZTS) bilayers as an effective hole-transport layer for perovskite solar cells

Interface Engineering of Low Temperature Processed All-Inorganic CsPbI2Br Perovskite Solar Cells Toward PCE Exceeding 14%