A Compact Readout Electronics Based on Current Amplifier for Micromegas Detector in Muon Imaging

Ting Wang,Yu Wang,Zhihang Yao,Yulin Liu,Changqing Feng,Zhiyong Zhang,Shubin Liu

2024-10-25

Abstract:Muon imaging technology is an innovative imaging technique that can be applied in volcano imaging, heavy nuclear material detection, and archaeological research. The Micromegas detector is a promising choice for muon imaging due to its high spatial resolution and large area. However, the large number of readout channels poses a challenge for electronics. In this paper, a compact front-end electronics (FEE) for reading Micromegas detectors is presented. The electronics use the commercial current-to-digital readout chip, ADAS1128, which integrates 128 current amplifiers for multi-channel charge measurement. After verifying the basic performance of the electronics, the energy resolution was obtained with a radioactive source. Furthermore, a muon imaging system prototype was set up and its spatial resolution was evaluated in a test with cosmic ray muons. The system prototype can reconstruct the boundaries of sufficiently massive objects with a size of 2 cm in a scattering imaging test.

Instrumentation and Detectors

What problem does this paper attempt to address?

The problem that this paper attempts to solve is: in muon imaging technology, how to design a compact and efficient read - out electronics system for a large - area Micromegas detector. Specifically, the paper mainly focuses on the following points:

1. **Multi - channel read - out challenges**: Due to the high spatial resolution and large coverage area of the Micromegas detector, it needs to handle a large number of read - out channels. Traditional read - out electronics devices are difficult to meet the requirements of such high - density multi - channel.

2. **Limitations of existing solutions**: Although existing application - specific integrated circuits (ASICs) are powerful, they are costly and large in size, not suitable for large - scale applications. While commercial chips simplify the output information to reduce costs, they can still effectively read out detector signals in some application scenarios.

3. **Requirements for low noise and high integration**: In order to accurately measure charged - particle events and read out a large number of detection units, the electronics system needs to have the characteristics of low noise and high integration.

### Solution

The paper proposes a compact front - end electronics (FEE) design based on the commercial current read - out chip ADAS1128. The ADAS1128 chip integrates 128 current amplifiers and is suitable for multi - channel charge measurement. By using this chip, the research team built a small prototype system and verified its performance.

### Main contributions

- **Compactness and integration**: The use of commercial chips has achieved a highly integrated read - out electronics system, significantly reducing the volume and cost of the system.
- **Low - noise characteristics**: The experimental results show that the root - mean - square (RMS) noise of this read - out electronics system is approximately 1.22 fC, meeting the requirements for low - noise read - out.
- **Spatial resolution**: For muons incident at a small angle, the spatial resolution of the detector is better than 200 µm.
- **Verification in practical applications**: Through scattering imaging tests, it has been proved that this system can reconstruct the boundaries of large enough objects (such as a 4 - cm - thick tungsten block) with a width of up to 2 cm.

### Summary

This research demonstrates the feasibility of using the commercial current read - out chip ADAS1128 to design a compact read - out electronics system for a large - area Micromegas detector. Especially in low - occupancy application scenarios, the ADAS1128 chip can meet the read - out requirements, and its high integration and miniaturization characteristics are conducive to the design of large - scale muon imaging read - out systems.