Abstract:Purpose:Silicon photomultiplier (SiPM) has recently emerged as a promising photodetector for biomedical imaging applications. Due to its high multiplication gain (comparable to PMT), fast timing, low cost and compactness, it is considered a good candidate for photon counting CT. Dark noise is a limiting factor which impacts both energy resolution and detection dynamic range. Our goal is to develop a comprehensive model for noise sources for SiPM sensors.Methods:The physical parameters used in this work were based upon a test SPAD fabricated in 130nm CMOS process. The SPAD uses an n+/p‐well junction, which is isolated from the p‐substrate by a deep n‐well junction. Inter‐avalanche time measurement was used to record the time interval between two adjacent avalanche pulses. After collecting 1×106 counts, the histogram was obtained and multiple exponential fitting process was used to extract the lifetime associated with the traps within the bandgap.Results:At room temperature, the breakdown voltage of the SPAD is ∼11.4V and shows a temperature coefficient of 7.7mV/°C. The dark noise of SPAD increases with both the excess biasing voltage and temperature. The primary dark counts from the model were validated against the measurement results. A maximum relative error of 8.7% is observed at 20 °C with an excess voltage of 0.5V. The probabilities of after‐pulsing are found to be dependent of both temperature and excess voltage. With 0.5V excess voltage, the after‐pulsing probability is 63.5% at ‐ 30 °C and drops to ∼6.6% at 40 °C.Conclusion:A comprehensive noise model for SPAD sensor was proposed. The model takes into account of static, dynamic and statistical behavior of SPADs. We believe that this is the first SPAD circuit simulation model that includes the band‐to‐band tunneling dark noise contribution and temporal dependence of the after‐pulsing probability.

Proton induced Dark Count Rate degradation in 150-nm CMOS Single-Photon Avalanche Diodes

Effect of Proton Irradiation on Complementary Metal Oxide Semiconductor (CMOS) Single-Photon Avalanche Diodes

Effects of X-Ray and γ-Ray Irradiations on 2-D-Planar and 3-D-Stacked CMOS SPADs

Protocols for healing radiation-damaged single-photon detectors suitable for space environment

Proton Irradiation Damage and Annealing Effects in ON Semiconductor J-Series Silicon Photomultipliers

Comparison of Proton and Gamma Irradiation on Single-Photon Avalanche Diodes

Impact of Silicide Layer on Single Photon Avalanche Diodes in a 130 Nm CMOS Process

Modeling of Hot-Carrier Degradation driven by silicon-hydrogen bond dissociation in SPADs

Improving Characterization Capabilities In New Single-Photon Avalanche Diode Research

Mitigating radiation damage of single photon detectors for space applications

Characterization of Single Photon Avalanche Diodes Fabricated by 0.13μm CMOS Technology

Characterization of small single photon avalanche diode fabricated using standard 180 nm CMOS process for digital SiPM

Noise optimization of single-photon avalanche diodes fabricated in 110 nm CMOS image sensor technology

Ultra-Low Dark Count Rate SPAD Fully Integrated in a 180 nm High-Voltage CMOS Process

Shallow Trench Isolation Patterning to Improve Photon Detection Probability of Single-Photon Avalanche Diodes Integrated in FD-SOI CMOS Technology

X-Ray and Proton Radiation Effects on 40 Nm CMOS Physically Unclonable Function Devices

Repeated radiation damage and thermal annealing of avalanche photodiodes

Research on proton displacement damage effects in charge-domain accumulation type TDI CMOS image sensors

TH‐CD‐207B‐07: Noise Modeling of Single Photon Avalanche Diode (SPAD) for Photon Counting CT Applications

Radiation-Induced Dose and Single Event Effects in Digital CMOS Image Sensors