Abstract:This article presents a resolution-tunable time-to-digital converter (TDC) with a three-level structure, in which the low-level TDC employs an improved all-digital delay-locked loop (ADDLL) based on a cyclic pulse ring oscillator (CPRO) and a digital controller for detection lock state (DLS). Specifically, a bidirectional bypass transmission delay unit (BBTDU) in CPRO provides adjustable resolution with a 15 ps coarse delay step and a 3.5 ps fine delay step. Second, a data processing approach is presented to open the window to extract a 4-bit binary data of the bidirectional serial shift register line (BSSRL) in ADDLL for DLS and update the values of BSSRL at the same position of windowing, which can reduce the number of manipulated registers in BSSRL by approximately 93.7%. Then, a methodology of detecting the locking pattern between lock and unlock and selecting the fixed optimal windowing sequence to update the controlling values of BSSRL is proposed to eliminate dithering in a locked state, which can reduce the clock phase jitter when locked. Finally, the proposed TDC has been integrated into a system-on-chip (SoC) and fabricated in 65-nm CMOS technology. The measurement results implemented with a 30 MHz reference clock demonstrate that a resolution-tunable TDC with low power has been obtained. There are six configurable resolutions in all. When configured to a minimum resolution of 7.78 ps, the power consumption and the precision are 4.812 mW and 3.02 ps, respectively. While configured for a maximum resolution of 29.7 ps, the power consumption and the precision are 2.874 mW and 13.2 ps, respectively. The proposed TDC is extremely flexible and well-suited for integration into other large-scale application-specific integrated circuit (ASIC) chips to extend the application range, especially for low-frequency applications.

An all-digital low-power, low-frequency GRO-based time to digital converter for biomedical applications

A Two-Step Time-to-Digital Converter with 5.6ps Resolution and 1 - 4255μs Measurement Range

A 0.013mm2 3.2ns Input Range 10-bit Cyclic Time-to-Digital Converter Using Gated Ring Oscillator With Phase Domain Reset in 65nm CMOS

A Review on Direct Digital Conversion Techniques for Biomedical Signal Acquisition

A low-power coarse-fine time-to-digital converter in 65nm CMOS

A Resolution-Tunable Low Power Time-to-Digital Converter With an Improved ADDLL Based on a Cyclic Pulse Ring Oscillator

A Time-to-Digital Converter for Low-Power Consumption Single Slope Analog-to-Digital Converters in a High-Speed CMOS Image Sensor

A Low-power Synthesizable Time-to-Digital Converter Using Amplification to Overcome Mismatch

A Multi-Path Gated Ring Oscillator Based Time-To-Digital Converter In 65 Nm Cmos Technology

A 3-step Low-latency Low-Power Multichannel Time-to-Digital Converter based on Time Residual Amplifier

A 10-Bit 563-Fs Step Constant-Slope Digital-to-Time Converter in 40-Nm CMOS with Nonlinearity Cancellation and Range Extension Techniques

A Low Power Tdc With 0.5ps Resolution For Adpll In 40nm Cmos

A 8bits, 6.2ps Resolution Two-Step Time-to-digital Converter with Set-Reset-based Arbiters and Signal Tracking Mechanism

A 1.3mW 8-bit Two-step Time-to-Digital Converter

Recent Developments and Design Challenges of High-Performance Ring Oscillator CMOS Time-to-Digital Converters

A 0.5-bit step multi-resolution adjustable-input range reconfigurable noise-shaping TDC using multi-step quantizer gated-ring oscillators

A 108fsrms 0.45mW 100MS/s 1.25MHz bandwidth multi-bit ΔΣ time-to-digital converter with dynamic element matching

A 1ps Resolution Two-Step Time-to-digital Converter Using Parallel Digital-to-time Converters

A High Resolution Time-to-Digital Converter (TDC) Based on Self-Calibrated Digital-to-Time Converter (DTC).

A Low Power Time-to-digital Converter for All-Digital Phase-Locked Loop

A 108fs(Rms) 0.45mw 100ms/S 1.25mhz Bandwidth Multi-Bit Delta Sigma Time-To-Digital Converter With Dynamic Element Matching