Abstract:The application requirements of high frame rate CMOS image sensors (CIS) in the industry have not been satisfied due to the speed limitations in traditional single-slope and serial two-step analog-to-digital converters (ADCs). In this paper, a high-speed fully differential two-step ADC design method for CIS was proposed. The proposed method was based on differential ramp and time-to-digital conversion (TDC) technology. A parallel conversion mode was formed that is different from serial conversion, and the robustness of the system was ensured due to the existence of differential ramps. Aiming at the inconsistency between traditional TDC technology and single-slope ADC, a TDC technology based on level coding was proposed. The proposed technology achieves the TDC in the last clock cycle of analog-to-digital conversion, and realized a two-step conversion process at another level. This paper presents a complete circuit design, layout design, and test verification of the proposed design method based on the 55 nm 1P4M CMOS experimental platform. Under the design environment of the analog voltage of 3.3 V, the digital voltage of 1.2 V, the clock frequency of 100 MHz, and a dynamic input range of 1.6 V, this design was a 12-bit ADC with a conversion time of 480 ns, column-level power consumption of 62 μW, differential nonlinearity (DNL) of +0.6/−0.6 LSB, and integral nonlinearity (INL) of +1.2/−1.4 LSB. Furthermore, it achieved a signal-to-noise distortion ratio (SNDR) of 70.08 dB. The proposed design provided a large area array with a high frame rate, and compared with the existing advanced single-slope ADC, its conversion speed increased by more than 52%. It provides an effective solution for the implementation of high frame frequency CIS.

A Time-to-Digital Converter for Low-Power Consumption Single Slope Analog-to-Digital Converters in a High-Speed CMOS Image Sensor

A 2.72 μ s row conversion time 11‐bit column‐parallel single‐slope analog to digital converter with differential‐clocks‐assisted time to digital converter interpolation for complementary metal oxide semiconductors image sensor

Low-Power Tdc Scheme Using Dll-Based Gray Counter for Infrared Imagers

A low power 10‐bit 1 MS/s cyclic analog to digital converter for complementary metal oxide semiconductors image sensors with comparator‐based switched‐capacitor technique

A Low-Power Column-Parallel Gain-Adaptive Single-Slope ADC for CMOS Image Sensors

An area‐effective and low‐power single‐slope ADC for DCG imaging CMOS image sensor

A Column-Parallel Inverter-Based Cyclic Adc for Cmos Image Sensor with Capacitance and Clock Scaling

A Low Power Tdc With 0.5ps Resolution For Adpll In 40nm Cmos

Two-Step Single-Slope ADC Utilizing Differential Ramps for CMOS Image Sensors

A 150 MS/s 10-Bit CMOS Pipelined Subranging ADC with Time Constant Reduction Technique.

A Comprehensive Methodology for Optimizing Read-Out Timing and Reference DAC Offset in High Frame Rate Image Sensing Systems

A 1ps Resolution Two-Step Time-to-digital Converter Using Parallel Digital-to-time Converters

A 1.8-V 14-Bit Inverter-Based Incremental Sigma Delta Adc For Cmos Image Sensor

A low-power coarse-fine time-to-digital converter in 65nm CMOS

High-Speed Fully Differential Two-Step ADC Design Method for CMOS Image Sensor

A 4-M Pixel High Dynamic Range, Low-Noise CMOS Image Sensor With Low-Power Counting ADC

Status Counting Double Edge Slope ADC for CMOS Image Sensors

An Energy-Efficient Readout Circuit Based on Incremental Delta-Sigma ADC with Decimation Filter for CMOS Image Sensors

A 1.8-V 14-bit inverter-based incremental ΣΔ ADC for CMOS image sensor.

A Low Power Up/Down Double-Data-Rate Counter For Cmos Image Sensors

A 63.2μW 11-Bit Column Parallel Single-Slope ADC with Power Supply Noise Suppression for CMOS Image Sensors.