A 0.5-bit step multi-resolution adjustable-input range reconfigurable noise-shaping TDC using multi-step quantizer gated-ring oscillators

Rania Hassan Mekky,Mourad N. El-Gamal
DOI: https://doi.org/10.1007/s10470-018-1126-4
IF: 1.321
2018-02-19
Analog Integrated Circuits and Signal Processing
Abstract:A reconfigurable noise-shaping time-to-digital converter (TDC) with adjustable resolution and input range is presented as a solution to nonlinear multi-input readout systems. By varying the frequency of a multi-step quantizer gated-ring oscillator (MSQ-GRO), the resolution and input range are adjusted without affecting the acquisition time. A prototype of a standalone second-order MASH MSQ-GRO-TDC operating over a 34 μs adjustable input range and covering five resolution modes is presented. The MSQ-GRO frequency changes by a factor of approximately 2\documentclass[12pt]{minimal}\usepackage{amsmath}\usepackage{wasysym}\usepackage{amsfonts}\usepackage{amssymb}\usepackage{amsbsy}\usepackage{mathrsfs}\usepackage{upgreek}\setlength{\oddsidemargin}{-69pt}\begin{document}$$\sqrt 2$$\end{document}, thus adjusting the resolution in steps of 0.5-bit. With a 12 MHz sampling frequency, the MSQ-GRO-TDC consumes 0.85 mW from a 1.2 V supply and achieves integrated noise of 42.8 and 1.9 psrms in 500 and 1 kHz bandwidths, respectively. The measured resolution is 13.3-to-15.3 bits with a sampling signal of 200 kHz in a 5 kHz bandwidth. The input range/resolution optimization allows up to 51% of power saving under the same supply voltage, thus extending the battery lifetime in portable devices. The MSQ-GRO-TDC is used as a data converter for a nonlinear pressure sensor. It achieves a worst-case resolution of 24.5 μbarrms. It is realized in a standard 0.13 μm CMOS technology and occupies an area of 0.145 mm2.
engineering, electrical & electronic,computer science, hardware & architecture
What problem does this paper attempt to address?