Abstract:We report an industrial compatible tunnel oxide passivated contact (TOPCon) structure on solar-grade p-type c-Si wafer as the rear emitter for high-efficiency solar cells, where the ultrathin silicon oxide (SiOx) is made by plasma-assisted oxidation and the P-doped n-type poly-Si (n+-poly-Si) contact layer by plasma-enhanced chemical vapor deposition (PECVD) of hydrogenated amorphous silicon (a-Si:H) with in-situ doping with PH3 and following the high-temperature annealing. The fabrication processes of SiOx and n+-poly-Si layers are systematically optimized. It is found that the optimized annealing temperature for the crystallization and dopant activation is in the range of 850 °C and 880 °C, which is higher than the similar structure with chemically oxidized SiOx (820 °C). In addition, the samples made with higher PH3/SiH4 doping ratio during the a-Si:H deposition need a lower annealing temperature to reach the similar dopant distribution within the samples made with lower doping ratio but annealed at higher temperature, it means that the optimized annealing temperature decreases with the increase of the PH3/SiH4 doping ratio during the deposition of a-Si:H precursor. The optimized process with post-hydrogenation yields excellent surface passivation on the p-type Si substrate with the implied open-circuit voltage (iVoc) of ∼742 mV, the single-side saturated recombination current density (J0) of ∼3.0 fA/cm2, the contact resistivity (ρc) of ∼2–4 mΩ cm2, and the effective minority carrier lifetime (τeff) of ∼1050 μs (Δn = 1 × 1015 cm-3). With these passivation parameters, a simulation study demonstrates the advantage of rear emitter over the conventional front emitter TOPCon solar cell with ∼22.8% achievable efficiency on solar-grade p-type wafers with current industrial constraints, and ∼24.9% on high quality p-type c-Si wafers with the optimized conditions in R&D laboratories. Our study suggests that the p-type c-Si solar cell with a rear n+-poly-Si TOPCon emitter is a viable structure for high-efficiency solar cell production.

Top performance whatever the doping

Silicon Quantum Dot Based Solar Cells: Addressing the Issues of Doping, Voltage and Current Transport

Silicon Nanocrystal Conjugated Polymer Hybrid Solar Cells with Improved Performance

Efficient Heterojunction Solar Cells on P-Type Crystal Silicon Wafers

Improved Device Performance of Si-based Heterojunction Solar Cells by Using Phosphorus Doped Si Nanocrystals Embedded in SiC Host Matrix

Simulation of a Silicon Heterojunction Solar Cell with a Gradient Doping Emitter Layer

An experimental investigation of spin-on doping optimization for enhanced electrical characteristics in silicon homojunction solar cells: Proof of concept

Enhancing the Selectivity and Transparency of the Electron Contact in Silicon Heterojunction Solar Cells by Phosphorus Catalytic Doping

TOPerc solar cell: An integral approach of TOPCon and PERC architectures for achieving efficiency beyond 25%

Doubling Power Conversion Efficiency of Si Solar Cells

Beyond the crystalline silicon solar cell mass-production—high energy-conversion-efficiency N-type back-junction front-contact and back-junction back-contact mono-crystalline silicon solar cells

Advancements in Passivation and Metallization Techniques for n-Type Monocrystalline Silicon Solar Cells

Electrical Performance, Loss Analysis, and Efficiency Potential of Industrial‐Type PERC, TOPCon, and SHJ Solar Cells: A Comparative Study

High Performance Nanostructured Silicon-Organic Quasi P-N Junction Solar Cells Via Low-Temperature Deposited Hole and Electron Selective Layer.

Reassessment of silicon heterojunction cell performance under operating conditions

Silicon solar cells: evolution, high-efficiency design and efficiency enhancements

An industrially viable TOPCon structure with both ultra-thin SiOx and n+-poly-Si processed by PECVD for p-type c-Si solar cells

The race for the best silicon bottom cell: Efficiency and cost evaluation of perovskite–silicon tandem solar cells

Optimized Phosphorus Diffusion Process and Performance Improvement of C-Si Solar Cell by Eliminating SiP Precipitates in the Emitter

Illumination-Induced Hole Doping for Performance Improvement of Graphene/n-Silicon Solar Cells with P3HT Interlayer

Performance of Bifacial Hit Solar Cells on N-Type Silicon Substrates