TOPerc solar cell: An integral approach of TOPCon and PERC architectures for achieving efficiency beyond 25%

S Sadhukhan,S Acharyya,T Panda,N C Mandal,G Das,S Maity,P Chaudhuri,S Chakraborty,Hiranmay Saha

DOI: https://doi.org/10.1002/ente.202300200

IF: 4.149

2023-07-18

Energy Technology

Abstract:P‐type mono PERC solar cell, the backbone of industrial manufacturing of solar cells for the past two years, has a roadmap for achieving >24% efficiency. The decrease of the recombination of minority carriers brought about by turning from full‐area rear metal contact to partial rear contact (<10%) accounts for the majority of the increase in efficiency of PERC solar cells over Al‐BSF solar cells which reached its maximum efficiency around 19.5%. P‐type TOPCon solar cells have achieved further improvement in efficiency ≥ 25% by completely removing the partial rear metal contact and introducing a thin tunneling oxide layer at the rear. But high lifetime of p‐type wafers and controlled porosity of the thin tunneling oxide layer and p‐type polysilicon conductivity are major challenges for P‐type TOPCon solar cells. Thus passivating the partial rear and front metal contacts using SiOx/poly‐Si tunnelling layer stacks and using SiNx on the front side and an AlOx/SiNx stack on the back to passivate the remaining areas might lead to further advancements in PERC solar cells. Therefore, by integrating TOPCon and PERC architectures, as originally proposed by Fraunhofer lab, a modified design known as TOPerc solar cell has been studied in depth in this paper. Using 3D Sentaurus TCAD simulation software, a thorough numerical simulation of a p‐TOPerc solar cell has been performed. It is shown that efficiency of 25.2% and 26.0% is obtained for a P‐type wafer of bulk lifetime of 400μs and 5.0ms respectively. This article is protected by copyright. All rights reserved.

energy & fuels