Abstract:Heterojunction with intrinsic thin-layer (HIT) solar cells attract attention due to their high open circuit voltage and stable performance. However, short circuit current density is difficult to improve due to light losses of transparent conductive oxide and hydrogenated amorphous silicon passivation (a-Si:H) layer and low absorption coefficient of crystalline silicon (c-Si). Silicon germanium alloy (Si/Si1-xGex) quantum wells and quantum dots are capable of improving low light utilization by strong optical absorption in the infrared region. In this article, opto-MoS2of the HIT solar cells integrated with Si/Si1-xGex quantum wells (HIT-QW) as a surface absorber are investigated by numerical simulation with Technology Computer Aided Design (TCAD). The influences of germanium content on the MoS2of HIT solar cells with long carrier lifetimes of Si1-xGex layers (p*) and defect-free a-Si:H/c-Si interface are investigated at first. The simulation results indicate that optical utilization in the infrared region is enhanced with the increase of germanium fraction, while open circuit voltage degrades due to the decreasing of the energy band gap of Si1-xGex, radiative recombination and auger recombination mechanism in the Si/Si1-xGex quantum wells. And the conversion efficiency reaches a maximum value at a germanium fraction of 0.25 then drops distinctly. When the germanium fraction increases from 0 to 0.25, the short circuit current density increases from 34.3 mA/cm2 to 34.8 mA/cm2, while the open circuit voltage declines from 749 mV to 733 mV. Hence, the conversion efficiency increases from 21.5% to 21.7% due to the fact that the enhancement of short circuit current density compensates for the reduction of open circuit voltage. When the germanium content increases to more than 50%, a serious open circuit voltage loss of more than 130 mV associated with the energy band gap loss of Si1-xGex arises in the HIT-QW solar cells, which indicates that the dominating carrier transport mechanism changes from shockley diffusion to recombination in the Si/Si1-xGex quantum wells. Subsequently, the influences of interface defects at a-Si:H/c-Si interface and bulk recombination centers in the Si/Si1-xGex quantum wells are discussed. Both interface holes at a-Si:H/c-Si interface and bulk holes in Si1-xGex quantum wells can be recombined through the interface defects at a-Si:H/c-Si interface and bulk recombination centers in the Si/Si1-xGex quantum wells, respectively, which restricts the position of hole fermi level in the open circuit condition. When the germanium fraction increases, the influence of interface defects at a-Si:H/c-Si interface becomes weak on the degradation of open circuit voltage compared with the significant influence of the bulk trap centers. Moreover, p* of longer than 510-5 s is necessary for the retention of electrical performance of HIT-QW solar cells by the simulation. Based on this research, high-efficiency HIT solar cells can be achieved by incorporating high-quality Si/Si0.75Ge0.25 quantum wells, which also requires the impactful passivation of a-Si:H/c-Si interface.

Performance of Bifacial Hit Solar Cells on N-Type Silicon Substrates

Enhanced Efficiency in Bifacial HIT Solar Cells by Gradient Doping with AFORS-HET Simulation

Simulation of heterojunction solar cells based on p-type silicon wafer

High-efficiency N-Type Silicon PERT Bifacial Solar Cells with Selective Emitters and Poly-Si Based Passivating Contacts

Bifacial p-Type PERC Solar Cell with Efficiency over 22% Using Laser Doped Selective Emitter

Silicon Homo-Heterojunction Solar Cells: A Promising Candidate to Realize High Performance More Stably

Heavy Boron-Doped Silicon Tunneling Inter-layer Enables Efficient Silicon Heterojunction Solar Cells

Bifacial silicon heterojunction solar cells using transparent‐conductive‐oxide‐ and dopant‐free electron‐selective contacts

Role of the Buffer at the Interface of Intrinsic A-Si:H and P-Type A-Si:H on Amorphous/crystalline Silicon Heterojunction Solar Cells

Study on P-a-Si:H properties of N-type heterogeneous junction solar cells manufactured by large-area parallel plate PECVD machine

Electrical performance analysis and optimization of monofacial and bifacial crystalline silicon solar cells

Surface Passivation Studies of n-type Crystalline Silicon for HIT Solar Cells

Impact of Boron Doping Concentration on Tunnel Oxide Passivated Contact in Front Surface for N-Type Poly-Si Based Passivated Contact Bifacial Solar Cells

Simulation of a high-efficiency silicon-based heterojunction solar cell

Numerical Simulation of Silicon Heterojunction Solar Cells with Si/Si1-xGex Quantum Wells

Impact of Surface Treatments on the Passivation Effect for N-Type Crystalline Silicon in Heterojunction Solar Cells

Investigation of a-Si (N+)/c-Si (P) hetero-junction solar cell through AFORS-HET simulation

A Technological Review of the Highly Efficient Heterojunction with Intrinsic Thin-layer (HIT)Solar Cells

Thin Al2O3 passivated boron emitter of n-type bifacial c-Si solar cells with industrial process

Efficient Heterojunction Solar Cells on P-Type Crystal Silicon Wafers

IMPACT OF WIDE BANDGAP P-TYPE NC-SI ON THE PERFORMANCE OF A-SI SOLAR CELLS