Abstract:As tellurides and selenides of Bismuth are extensively used thermoelectric materials in the low-temperature range with refrigeration application, A concerted effort is put forth to boost the ZT by co-doping the pristine Bi 2 Se 3 with antimony (Sb) on cation end and tellurium (Te) on anion side of the compound. The double sintered solid-state reaction method is employed in the preparation of Bi 2 Se 3 and (Bi 1− x Sb x ) 2 Se 2.7 Te 0.3 polycrystalline pellets, with x = 0.02, 0.04, and 0.06. The sample exhibits a rhombohedral structure with the space group of R m. FESEM and EDAX analysis are used to confirm surface morphology and elemental composition of the produced samples. The thermoelectric measurements for the pristine and co-doped samples were conducted by the physical property measurement system as well as a considerable increase in the Seebeck coefficient of − 115 μV/K is observed for 0.02 doping of the Sb which is 4.2 times greater than as for pristine (S = − 28 μV/K). Higher concentration doping ( x = 0.04, 0.06) has not reflected any Seebeck coefficient advancement. In contrast, the lowest total thermal conductivity at a low-temperature regime (< 50 K) is observed for x = 0.06 doping concentration which at near room temperature increases beyond the pristine thermal conductivity; whereas, x = 0.02, 0.04 doping concentration shows a decrement in total thermal conductivity at low, at room temperature region the values are almost equivalent to that of pristine. The co-doped samples' electrical resistivity is substantially less than pristine sample. The highest power factor of 3 × 10 –4 μW/mK 2 is obtained for the x = 0.02 sample. The highest ZT value for the x = 0.02 sample is almost 28 times more than a pristine sample. We conducted a study where we combined experimental and DFT methods to investigate thermoelectric properties incorporated into pristine and doped with antimony and tellurium on Bi 2 Se 3 . We have employed this combination to investigate the partial density of states, Seebeck coefficient, power factor using the Boltzmann transport equation. Theoretical thermoelectric data were derived and compared to experimental observations. Hence, using combined experimental and theoretical investigations helps to predict with higher accuracy of thermoelectric properties of semiconducting materials.

Combining theory and experiment to determine thermoelectrics of tellurium doped CoSb3

A comprehensive experimental and DFT analysis on thermoelectric properties of Sb, Te co-doped Bi2Se3 polycrystals

A First-principles approach to predict Seebeck coefficients: Application to La3-xTe4

Electronic structure and low-temperature thermoelectric transport of TiCoSb single crystals

The effect of energy-dependent electron scattering on thermoelectric transport in novel topological semimetal CoSi

Combination of Carrier Concentration Regulation and High Band Degeneracy for Enhanced Thermoelectric Performance of Cu3SbSe4

Enhanced Thermoelectric Performance Of (Sb0.75bi0.25)(2)Te-3 Compound From First-Principles Calculations

Thermoelectric Properties of S and Te-doped Cu2SnSe3 Prepared by Combustion Synthesis

Unlocking the Potential of Cu3SbSe3: Ultralow Thermal Conductivity and Enhanced Thermoelectric Performance

Enhanced thermoelectric performance of CoSbS via Se doping at dual Sb and S sites

Synergistically Optimizing Electrical and Thermal Transport Properties of ZrCoSb through Ru Doping

Electronic Origin for the Enhanced Thermoelectric Efficiency of Cu2Se

Thermoelectric Properties of Doped-Cu3SbSe4 Compounds: A First-Principles Insight

DFT studies on electronic and structure properties of PbSe 1-x S x alloys for thermoelectric materials using VCA and RS.

Electronic origin of the enhanced thermoelectric efficiency of Cu2Se

Enhanced Thermoelectric Performance of Cu2Se Alloys by Simultaneous Engineering of Thermal and Electrical Transport Properties Through S and Te co‐doping

Quasi-two-dimensional GeSbTe compounds as promising thermoelectric materials with anisotropic transport properties

Realizing High Thermoelectric Performance in GeTe‐Based Supersaturated Solid Solutions

Enhancing thermoelectric performance of Sn1-Sb2/3Te via synergistic charge balanced compensation doping

First-Principles Study of Doped CdX(X=Te,Se) Compounds: Enhancing Thermoelectric Properties

Modulation Doping of P-Type Cu12Sb4S13 Toward Improving Thermoelectric Performance