Electronic origin of the enhanced thermoelectric efficiency of Cu2Se

Shucui Sun,Yiwei Li,Yujie Chen,Xiang Xu,Lu Kang,Jingsong Zhou,Wei Xia,Shuai Liu,Meixiao Wang,Juan Jiang,Aiji Liang,Ding Pei,Kunpeng Zhao,Pengfei Qiu,Xun Shi,Lidong Chen,Yanfeng Guo,Zhengguo Wang,Yan Zhang,Zhongkai Liu,Lexian Yang,Yulin Chen
DOI: https://doi.org/10.1016/j.scib.2020.07.007
IF: 18.9
2020-11-01
Science Bulletin
Abstract:Thermoelectric materials (TMs) can uniquely convert waste heat into electricity, which provides a potential solution for the global energy crisis that is increasingly severe. Bulk Cu<sub>2</sub>Se, with ionic conductivity of Cu ions, exhibits a significant enhancement of its thermoelectric figure of merit zT by a factor of ~3 near its structural transition around 400 K. Here, we show a systematic study of the electronic structure of Cu<sub>2</sub>Se and its temperature evolution using high-resolution angle-resolved photoemission spectroscopy. Upon heating across the structural transition, the electronic states near the corner of the Brillouin zone gradually disappear, while the bands near the centre of Brillouin zone shift abruptly towards high binding energies and develop an energy gap. Interestingly, the observed band reconstruction well reproduces the temperature evolution of the Seebeck coefficient of Cu<sub>2</sub>Se, providing an electronic origin for the drastic enhancement of the thermoelectric performance near 400 K. The current results not only bridge among structural phase transition, electronic structures and thermoelectric properties in a condensed matter system, but also provide valuable insights into the search and design of new generation of thermoelectric materials.
multidisciplinary sciences
What problem does this paper attempt to address?
The problem that this paper attempts to solve is to explore the electronic origin of the significant improvement in the thermoelectric properties of Cu2Se near 400 K. Specifically, the authors systematically studied the electronic structure of Cu2Se and its variation with temperature, especially its behavior near the structural phase transition, through high - resolution angle - resolved photoemission spectroscopy (ARPES). The study found that during the transition of Cu2Se from the low - temperature α - phase to the high - temperature β - phase, the reconstruction of the electronic band plays a crucial role in the sharp increase of the Seebeck coefficient, thus explaining the significant improvement in its thermoelectric figure of merit (zT). In addition, the disorder of Cu+ ions also leads to a decrease in the lattice thermal conductivity, further improving the thermoelectric properties of the material. ### Key Findings 1. **Reconstruction of the Electronic Band**: Near the structural phase - transition point close to 400 K, an energy gap of about 150 meV is formed near the Γ point in the electronic band of Cu2Se, which is closely related to the sharp increase in the Seebeck coefficient. 2. **Structural Phase Transition**: Through X - ray diffraction (XRD) measurements, it was confirmed that Cu2Se undergoes a structural phase transition from the α - phase to the β - phase near 400 K, manifested as a sudden change in the XRD peak position. 3. **Behavior of Cu+ Ions**: The rearrangement and migration of Cu+ ions play an important role in the reconstruction of the electronic band and the decrease in the lattice thermal conductivity. ### Formula The Seebeck coefficient \( S \) mentioned in the paper can be approximately calculated by the following formula: \[ S=\frac{2\pi^{2}k_{B}^{2}T}{3e}\left.\frac{d\ln N(E)}{dE}\right|_{E = E_{F}} \] where: - \( k_{B} \) is the Boltzmann constant. - \( e \) is the electron charge. - \( N(E) \) is the density of states. - \( E_{F} \) is the Fermi level. ### Conclusion Through systematic ARPES and XRD studies, the authors revealed the phenomenon of electronic band reconstruction in Cu2Se during the structural phase transition and demonstrated that this phenomenon is the main reason for the significant improvement in its thermoelectric properties. These findings not only help to understand the unique thermoelectric behavior of Cu2Se but also provide important insights for the design of a new generation of thermoelectric materials.