Abstract:Aluminum foam that is lightweight with high specific strength, high energy absorption and other characteristics can be used in aerospace, transportation, machinery manufacturing and other fields. The PCM method is usually used to prepare closed-cell aluminum foams. The microsized aluminum foams made by this process can solve the non-uniform pore structures caused by liquid drainage during the foaming process of large aluminum foams. The surface morphology and internal pore structure of microsized aluminum foams are affected by the quality of the precursor used for foaming. In this paper, foamable precursors were obtained via either hot rolling or hot extrusion and subsequently foamed. By analyzing the micromorphology and foaming process of the precursor, the influence of the technological method on the macroscopic pore structure of the final aluminum foam was studied. The results show that the aluminum powder particles in the precursor prepared with the hot rolling method had metallurgical bonding, and the outer surface was dense, with almost no porosity and holes in the interior. The microsized aluminum foam obtained after foaming was smooth in appearance, and the internal pore structure was round and uniform. The reason is that during the foaming process of microsize aluminum foam, the foaming agent was evenly distributed in the precursor of the hot rolling process because of its compact structure. During the foaming process, the decomposed gas of the foaming agent will not escape, and the evenly distributed foaming agent tends to nucleate in situ. In the process of rapid foaming, the pressure in the bubble is enough to resist the liquid drainage phenomenon caused by gravity, and the growth direction of the gas core is isotropic, which promotes the foam structure to be more rounded and uniform.

Method for sintering and preparing 7-series foam aluminum alloy material through pore-forming agent method

Factors affecting the microstructure of a fine ceramic foam

Fabrication of Aluminum Foams with Small Pore Size by Melt Foaming Method

Effect of Shape of Pore Forming Agent on Structure and Properties of Aluminum Foams

Preparation of Aluminum Foam by Gas Injection Foaming

Preparation of complex shaped aluminum foam by a novel casting-foaming method

Development of AlMg35-TiH2 composite foaming agent and fabrication of small pore size aluminium foams

Preparation, Characterization and Designing of Porous Ti–6Al–4V Through Metal Injection Molding Without Space Holder

Aluminum Foam Sandwich: Pore Evolution Mechanism Investigation and Engineering Preparing Optimization

Optimization of Cellular Structure of Aluminum Foams Produced by Powder Metallurgy Method

Fabrication of porous aluminum composites containing hollow ceramics

Preparation Technology of Aluminum Foam Sandwich Panels by Powder Metallurgy and Optimization of Cellular Structure

Fabrication of Mg-Al Alloy Foam with Close-Cell Structure by Powder Metallurgy Approach and Its Mechanical Properties

Foaming Process and Properties of 6063 Aluminum Foams by Melt Foaming Method

Fabrication of Cu-Mg alloy foam with close pore structure by gas release reaction powder metallurgical approach

Preparation of Shaped Aluminum Foam Parts by Investment Casting

Foaming Behavior of Microsized Aluminum Foam Using Hot Rolling Precursor

Preparation of Porous Composite Materials through Silicon Component Foaming and Special Heat Treatment

Microstructural characteristics and mechanical properties of 7075 aluminum alloy foam sandwich panels fabricated via integrated forming and foaming

Design and Formulation of Polyurethane Foam Used for Porous Alumina Ceramics