Abstract:Controlling the properties of nano-sized copper oxide (CuO) is an interesting approach for broadening its multifunctionality. This paper reports the deposition of CuO thin films on ultrasonically cleaned glass substrates. The sol–gel spin coating technique was employed to prepare un-doped films with different thickness, Ni-doped and (La, Ni) co-doped CuO films in the formulas; Cu1−xNixO (0 ≤ x ≤ 0.06) and Cu0.94−yNi0.06LayO (0.02 ≤ y ≤ 0.06). The structural and morphological properties were studied by X-ray diffraction (XRD), Fourier transformation infrared (FTIR) spectroscopy, and atomic force microscopy (AFM). The optical and wetting properties were investigated by UV–Vis spectrophotometer and water contact angle (WCA) measurement, respectively. XRD and FTIR results confirm the synthesis of nanostructured CuO of monoclinic structure. The average crystallite size, D, is dependent on the number of the coated layers of the pure CuO film. The value of D increased from 22.2 nm for the four-layered CuO film to 24.2 nm upon the incorporation of 6 % Ni content. Then, it decreased to 11.4 nm after the co-doping with 6 % La. Ni doping improved the (002) preferential orientation and La co-doping reduced the crystallinity of the films. The films are hydrophilic and their wetting properties were enhanced by increasing the film thickness and La incorporation. Ni and La co-doping could efficiently control transmittance, optical band gap, and the refractive index of the films. The existence of stable copper oxide films at room temperature with band gaps around 2.0 eV supports their use in catalysts and gas sensing applications as well as in optoelectronics and solar technologies.

Optical properties of spin coated and sol-gel dip coated cupric oxide thin films

Spin Coated Multilayered Cupric Oxide Thin Films and their structural properties

Characterizations of Cuprous Oxide Thin Films Prepared by Sol-Gel Spin Coating Technique with Different Additives for the Photoelectrochemical Solar Cell

Investigating the role of film thickness on the physical properties of sol-gel coated CuO thin films: Discussing its potentiality in optoelectronic applications

Optical properties of spin coated Cu doped ZnO nanocomposite films

Effect of Cu Concentration on Optical Properties of Zn1-xCuxO Thin Films

Characterization of spin coated Zn doped cupric oxide thin films

Effect of Annealing Temperature and CuO on Microstructure and Optical Band Gap of CuxZn1−xO Thin Films

Photocurrent enhancement of spin coated CdS thin films by adding Cu

Microstructure, Morphology and Sunlight Response of Cuprous Oxide Thin Films

Optical and Wetting Properties of CuAlO2 Films Prepared by Radio Frequency Magnetron Sputtering

Effect of Post-annealing Temperature on Microstructural, Morphological and Optical Properties of Sol–gel Spin Coated Cu Doped SnO2 Thin Films

Effects of withdrawal speeds on the structural, morphological, electrical, and optical properties of CuO thin films synthesized by dip-coating for CO2 gas sensing

Structural, morphological, optical properties and wettability of spin-coated copper oxide; influences of film thickness, Ni, and (La, Ni) co-doping

Impedance and electrical properties of Cu doped ZnO thin films

Optical and Electrical Properties of Copper Oxide Thin Films Synthesized by Spray Pyrolysis Technique

Investigation of optical bandgap variation and photoluminescence behavior in nanocrystalline CuO thin films

Effects of Coating Methods on Microstructure and Optical Properties of Mesoporous Silica Films

Structural and optical properties of thermally treated CdO thin films deposited on ITO coated glass substrates for photovoltaic applications

Electrical and optical properties of copper oxide thin films prepared by DC magnetron sputtering

Investigation of the Doping and Withdrawal Speed Effect on the Properties of sol–gel Dip-coated Cu-Doped ZnO Thin Films