Abstract:This study investigates the fabrication process of copper thin films via thermal evaporation, with precise control over film thickness achieved throughZ-position adjustment. Analysis of the as-fabricated copper films reveals a discernible relationship between grain size (〈D〉) andZ-position, characterized by a phenomenological equation〈D〉XRDn(Z)=〈D〉0n1+32rZ2+158rZ4, which is further supported by a growth exponent (n) of 0.41 obtained from the analysis. This value aligns well with findings in the literature concerning the growth of copper films, thus underlining the validity and reliability of our experimental outcomes. The resulting crystallites, ranging in size from 20 to 26 nm, exhibit a resistivity within the range of 3.3-4.6μΩ · cm. Upon thermal annealing at 200 °C, cuprite Cu2O thin films are produced, demonstrating crystallite sizes ranging from ∼9 to ∼24 nm with increasing film thickness. The observed monotonic reduction in Cu2O crystallites relative to film thickness is attributed to a recrystallization process, indicating amorphization when oxygen atoms are introduced, followed by the nucleation and growth of newly formed copper oxide phase. Changes in the optical bandgap of the Cu2O films, ranging from 2.31 to 2.07 eV, are attributed mainly to the quantum confinement effect, particularly important in Cu2O with size close than the Bohr exciton diameter (5 nm) of the Cu2O. Additionally, correlations between refractive index and extinction coefficient with film thickness are observed, notably a linear relationship between refractive index and charge carrier density. Electrical measurements confirm the presence of a p-type semiconductor with carrier concentrations of ∼1014cm-3, showing a slight decrease with film thickness. This phenomenon is likely attributed to escalating film roughness, which introduces supplementary scattering mechanisms for charge carriers, leading to a resistivity increase, especially as the roughness approaches or surpasses the mean free path of charge carriers (8.61 nm). Moreover,ab-initiocalculations on the Cu2O crystalline phase to investigate the impact of hydrostatic strain on its electronic and optical properties was conducted. We believe that our findings provide crucial insights that support the elucidation of the experimental results. Notably, thinner cuprite films exhibit heightened sensitivity to ethanol gas at room temperature, indicating potential for highly responsive gas sensors, particularly for ethanol breath testing, with significant implications for portable device applications.

Investigating the role of film thickness on the physical properties of sol-gel coated CuO thin films: Discussing its potentiality in optoelectronic applications

Changes in the structural and optical properties of CeO2 nanocrystalline films: Effect of film thickness

Microstructure, surface morphology and optical properties of Na x Cu y Zn 1− x − y O thin films

Effect of Cu Concentration on Optical Properties of Zn1-xCuxO Thin Films

Effect of Annealing Temperature and CuO on Microstructure and Optical Band Gap of CuxZn1−xO Thin Films

Optical properties of spin coated and sol-gel dip coated cupric oxide thin films

Effect of film thickness on structural and optical properties of sol-gel spin coated aluminum doped zinc oxide (Al:ZnO) thin films

Film thickness effect on structural, optical and electrical properties of indium oxide (In2O3) thin films grown via sol-gel method

Spin Coated Multilayered Cupric Oxide Thin Films and their structural properties

Impact of film thickness on optical properties and optoelectrical parameters of novel CuGaGeSe4 thin films synthesized by electron beam deposition

Thickness dependence of the room-temperature ethanol sensor properties of Cu2O polycrystalline films

Effects of withdrawal speeds on the structural, morphological, electrical, and optical properties of CuO thin films synthesized by dip-coating for CO2 gas sensing

Structural, morphological, optical properties and wettability of spin-coated copper oxide; influences of film thickness, Ni, and (La, Ni) co-doping

Characterizations of Cuprous Oxide Thin Films Prepared by Sol-Gel Spin Coating Technique with Different Additives for the Photoelectrochemical Solar Cell

Influences of Film Thickness on the Structural, Electrical and Optical Properties of CuAlO2 Thin Films

Investigation of the structural, morphological, optical, and electrical properties of thin films: application of effective medium theories to CdO/Co3O4 composites

Investigation on the Structural and Optical Properties of ZnO Thin Films Prepared by Sol-Gel Method

Investigating the opto-electronic and photovoltaic properties of Zn-incorporated CuO thin film grown by vapor–liquid–solid (VLS) method

Performance of SnO2 Thin Film Prepared by CWD Technique on Different Substrates for Device Applications: An Innovative Approach

Optical and Electrical Properties of Copper Oxide Thin Films Synthesized by Spray Pyrolysis Technique

Tuning optical and electrical characteristics through Cu doping in spray pyrolysis fabricated Cr 2 O 3 thin films