Tuning optical and electrical characteristics through Cu doping in spray pyrolysis fabricated Cr 2 O 3 thin films

Mohsin Ishtiaq,Dilawar Ali,R. Ahmad,Iqra Muneer,Taj M. Khan
DOI: https://doi.org/10.1016/j.optmat.2024.114930
IF: 3.754
2024-01-25
Optical Materials
Abstract:This study focuses on the physical properties of thin films of Cr 2 O 3 and Cu-doped Cr 2 O 3 (1−4 % Cu), with a thickness of approximately ∼500 nm. These films were deposited on preheated soda-lime glass substrates using the spray pyrolysis technique. The characterization of the thin films was carried out through Raman spectroscopy, UV–visible spectroscopy, and the four-point probe technique. The Raman analysis revealed vibrational modes associated with E g and A 1g symmetries in Cr 2 O 3 . The optical band gap energy exhibited a decrease from 2.92 eV to 2.6 eV with an increase in Cu content. The study also involved the evaluation of extinction coefficient, refractive index, dielectric constants, and optical conductivity of the thin films. The dispersion of the refractive index was studied using the single oscillator model (Wemple-DiDomenico). The electrical resistivity values decreased from 1000 Ω-cm to 33 Ω-cm with increasing Cu content. Notably, Cr 2 O 3 thin films with 4 % Cu content demonstrated the best figure of merit, recording a value of 4.66 M Ω −1 .
materials science, multidisciplinary,optics
What problem does this paper attempt to address?