Development of Si-CMOS hybrid detectors towards electron tracking based Compton imaging in semiconductor detectors

Hiroki Yoneda,Shinya Saito,Shin Watanabe,Hirokazu Ikeda,Tadayuki Takahashi
DOI: https://doi.org/10.1016/j.nima.2017.11.078
2017-12-05
Abstract:Electron tracking based Compton imaging is a key technique to improve the sensitivity of Compton cameras by measuring the initial direction of recoiled electrons. To realize this technique in semiconductor Compton cameras, we propose a new detector concept, Si-CMOS hybrid detector. It is a Si detector bump-bonded to a CMOS readout integrated circuit to obtain electron trajectory images. To acquire the energy and the event timing, signals from N-side are also read out in this concept. By using an ASIC for the N-side readout, the timing resolution of few us is achieved. In this paper, we present the results of two prototypes with 20 um pitch pixels. The images of the recoiled electron trajectories are obtained with them successfully. The energy resolutions (FWHM) are 4.1 keV (CMOS) and 1.4 keV (N-side) at 59.5 keV. In addition, we confirmed that the initial direction of the electron is determined using the reconstruction algorithm based on the graph theory approach. These results show that Si-CMOS hybrid detectors can be used for electron tracking based Compton imaging.
Instrumentation and Methods for Astrophysics,Instrumentation and Detectors
What problem does this paper attempt to address?
This paper aims to solve the problem of improving the sensitivity of semiconductor Compton cameras in gamma - ray imaging. Specifically, this goal is achieved by measuring the initial direction of recoil electrons. Although traditional semiconductor Compton cameras have the advantages of high density and high energy resolution, in practical applications, electron tracking can only be achieved under limited conditions. To overcome these limitations, the authors propose a new detector concept - the Si - CMOS hybrid detector, which can image electron trajectories and has high spatial resolution and high temporal resolution. ### Main problems 1. **Improving the sensitivity of Compton cameras**: - Traditional methods determine the incident direction of gamma - rays by measuring the position of Compton scattering and the deposited energy, but this method requires a large number of photons to statistically significantly identify a specific intersection. - By measuring the initial direction of recoil electrons, the incident direction of gamma - rays can be restricted to a smaller area, thus reducing the number of photons required. 2. **Achieving high - resolution electron trajectory imaging**: - To resolve electron trajectories of about 100 μm, a spatial resolution of about 10 μm is required. - A fast temporal resolution (< 10 μs) is required to identify coincidence events in scattering and absorption detectors. - The thickness of the detector should be about 500 μm to ensure high energy efficiency and electron trajectory length. ### Solutions - **Si - CMOS hybrid detector**: - This detector consists of a Si detector and a CMOS read - out integrated circuit (ROIC), which are connected by micro - bump bonding. - The CMOS ROIC is used to obtain electron trajectory images and simultaneously read out signals from the N - side to measure electron energy and event time. - An ASIC is used for N - side read - out to achieve a temporal resolution of a few microseconds. ### Experimental results - **Prototype 1**: - The number of pixels is 128 × 128, the detector size is 2.56 mm × 2.56 mm, and the thickness is 0.5 mm. - Electron trajectory images were successfully obtained, and the energy resolution (FWHM) was 4.1 keV (6.9%). - **Prototype 2**: - The number of pixels increased to 640 × 640, the detector size was 12.8 mm × 12.8 mm, and the thickness was the same as that of Prototype 1. - The energy resolution (FWHM) was 1.4 keV (2.3%), but there was a problem of interference noise. ### Reconstruction algorithms - **Electron trajectory reconstruction algorithm based on graph theory**: - The center point of each pixel is regarded as a vertex of the graph, and the connection between adjacent pixels is regarded as an edge. - Calculate the center of gravity of the pixels and replace the node positions to better track electron trajectories. - Select the longest shortest path as the electron trajectory. - Determine the Compton scattering position and apply principal component analysis to determine the direction of the initial electron momentum. ### Conclusions - By developing the Si - CMOS hybrid detector, electron trajectory imaging was successfully achieved and electron energy was measured. - The developed reconstruction algorithm based on graph theory can effectively determine the direction of the initial electron momentum. - Future work will focus on increasing the frame rate and further optimizing detector performance.